air conditioner question

greenstreak

Member
exMember
Joined
Mar 8, 2004
RO Number
12942
Messages
320
I just bought a boat that has Mermaid air/heat. The heat side is a heat strip. I have never seen that on a boat. I thought all air conditioners were reverse heat. anybody else have one or seen one with heat strip? Also, which one is better of the 2?

Thanks

art
 
most systems use reverse cycle... the benefit of heat strip is that you dont' use the compressor and water pump so less wear. Not sure if there are any downsides, maybe use more power and a slightly higher risk of fire maybe just maybe if the fan fail? not sure...
 
One advantage the heat strips have over reverse cycle is the fact that reverse cycle heat becomes less efficient as the water temp. drops. And stops working altogeather once the water gets cold enough. While heat strips work reguardless of water temp.. And you don't have to worry about the reverse cycle valve becoming stuck over the summer. :-)

Heat strips due tend to draw more of an amp load though as I recall.
 
thanks guys for the information. Well, there is a safety just in case the fan quit so there isn't an overheating problem with the strip. We already burned the piece out cause we were testing the heat side and the fan wouldn't come on when the heat was switched to. Finally we even lost heat. We had to call an air conditioner man to come out and he found it right away. He said it was a safety. He has to replace it but I forget what he called the inline piece. He said since we ran the heat for a while it burned the piece out. He said it cost about $40 from Mermaid but only $3 from radio shack. The fan wasn't kicking on in heat mode cause the thermostat wasn't working right.

thanks
art
 
Depends on the location. In the north, heat strips are not uncommon. IIRC, the Canadian naval forces use them. They are very effective though not all efficient from an underway perspective. I have a heat pump on Saint Max. However at the slip, I use a small quartz heater. I looked at the Flagship Marine AC/Heat when looking to HVAC the Regal. It takes away far more humidity.
 
Safetys are required on elect. heaters, they have been for a few years.
Too many houses burned down because they didn't have them.
Same with elect. dryers. They use small button type thermostats to
keep the units from getting too hot. Some are manual reset, some auto reset.
They are called limit switches. They are usually inline on the hot wire
and cut out when it gets too hot, shutting off power to the heat strip.
 
GE makes a line of airconditioner products called "ZoneLine". These are unit airconditioner/heaters in which reverse cycle air is used for heating until the outside air temperature gets too low at which point the machine switches to a electrical resistance heater (heat strip). Any modern motel will have these units. Most condos have them where it is not practical to have central heat.

It is far less common to have them on a boat because there are so few that boat when it is that cold.

The old Bayliner Explorer series (32+ feet) had, IMO, the proper setup: Two reverse cycle airconditioners plus three separate electric heaters plus a heating coil, fan forced, working off the engine heat.
 
On home heat pumps, it is called emergency heat when the heat strips kick on.
A light on the thermostat usually comes on telling you that it is on.
There is also a differential pressure sensor across the outside coils that
tell you when the coils are froze up. Then a heater coil in the cond. coil
comes on to help defrost them.
I don't know how you could do this on a small water cooled a/c.
On work and crew boats in the oilfield, they have a pressure sensor on the freon
high side line that throttles a valve on the water inlet to the exchanger.
But these units are 10 ton and bigger.
 
quote:

Originally posted by greenstreak

thanks guys for the information. Well, there is a safety just in case the fan quit so there isn't an overheating problem with the strip. We already burned the piece out cause we were testing the heat side and the fan wouldn't come on when the heat was switched to. Finally we even lost heat. We had to call an air conditioner man to come out and he found it right away. He said it was a safety. He has to replace it but I forget what he called the inline piece. He said since we ran the heat for a while it burned the piece out. He said it cost about $40 from Mermaid but only $3 from radio shack. The fan wasn't kicking on in heat mode cause the thermostat wasn't working right.

thanks
art






Well, that would probably be a "thermal fuse".

pRS1C-2265104t98.jpg


They come in several heat ratings so be sure to get the correct one.
 
I have one with a heating coil. Its great. No noise, no water cooling needed. There is no chance of fire on mine, its surrounded by the metal frame (as I would think they all are) One nice thing about it is when I want to work on the boat in the winter, I just turn it on.
 
Heat strips are limited to about 5000 BTUs. Reverse cycle units will heat as much or slightly more than cooling BTU rating. Reverse cycle units are more desirable, also more expensive.
 
Back
Top