Automotive equivalent

tinytanic1

Member
Joined
Mar 14, 2002
RO Number
7864
Messages
4
I have a Mercruiser 120hp, 2.5L, 4-Cyl. It's a GM block. I believe the year is about 1977 (or close to it). The Mod# is MCM120, Sn# 4658436.
Does anyone know what the auto engine equivalent is to this.
 
2.5L - 151 cid 4 cylinder. Popular in many small-mid sized GM cars, trucks. Here are a few models which were offered with this engine.

Chevrolet Celebrity
Chevy S-10 pickup
Chevy Camaro, Firebird

The list could go on...hope this is what you need.
 
Don't know how big the range is, but I had one in an '89 Grand Am. Great motor that would've lasted longer if I hadn't fragged the trans
 
Camaro & Firebird?? Please tell me they never put 4 bangers in them!
 
In the mid-west they put those little 4-bangers in the full size cars. The road tax was less with less HP.

If your looking for a block, your in Competition with the Wing car dirt racers. They gobble em' up quick.
If you buy one from those guys, make sure they havn't cut all the Boss's off the block. They take 70 lbs or so of extra metal off the block before they start customizing it.

I had a heckuva time finding a used block. I finall bought a Boat, to get the engine. I also found a used engine up in Vancouver Island BC.

You may be able to put the old Six inplace of the four. The boat I bought was fitted for both.
 
quote:

Originally posted by sugilbert

Camaro & Firebird?? Please tell me they never put 4 bangers in them!






Afraid so...the F-bodies (Camaro-Firebird)had them through '86. The old "Iron Duke" as we called them motors.
 
A pony car with a 4 banger is a eunich.
 
I had two Chevy's with the Iron Duke engine. When I got rid of the cars - at 16 and 17 years old - the motors ran like new. A fine bullet proof little motor.
 
Were you planning on a re-power of the Boat with the car motor? Big mistake if you are.
 
Using an automotive block casting is no problem if you use the correct marine parts in the assembly. Marine engines will have brass freeze plugs and a marine gasket set should be used.
 
From what I gather from reading here these past few years I THINK there's a bit more to it than that.
Aren't there some differences in the internals themselves? ie; Crank...Cam...Pistons...etc. etc.?
 
quote:

Originally posted by Tanqueray

From what I gather from reading here these past few years I THINK there's a bit more to it than that.
Aren't there some differences in the internals themselves? ie; Crank...Cam...Pistons...etc. etc.?






Yes.
 
The 2.5 liter 120 hp engine is way older than you are inferring. It is actually from the Chevy II Nova, and is not the same engine used in the 1980's. Look at it carefully and you'll se how absolutely low tech it is...even by 1980's standards.
 
Back
Top