Went back into the water again today.
I was able to get a real good look at the shaft and cutlass bearing area. Found that the strands were still there even though I have run about 20 miles!!
I tried pulling them out but couldn't get a grip on them. So I took a small screwdriver and dug out one area then grabbed it with a pair of needle nose pliers.
When I pulled it out a piece of rope about three inches long came out from around the shaft! It had melted some but came out completely. I inspected the area all the way around the shaft and found no further residue.
Problem solved!
Thanks for all the input!
One point ot remember...
The water is much colder up here in the PNW and I couldn't stay in the water long enough to do all that last week!
I was able to get a real good look at the shaft and cutlass bearing area. Found that the strands were still there even though I have run about 20 miles!!
I tried pulling them out but couldn't get a grip on them. So I took a small screwdriver and dug out one area then grabbed it with a pair of needle nose pliers.
When I pulled it out a piece of rope about three inches long came out from around the shaft! It had melted some but came out completely. I inspected the area all the way around the shaft and found no further residue.
Problem solved!
Thanks for all the input!
One point ot remember...
The water is much colder up here in the PNW and I couldn't stay in the water long enough to do all that last week!