Inflatable Keel

quote:

Originally posted by yzer

Grady, that safety valve works for the main chambers that run a higher PSI than the inflatable keel. Best to stop foot pumping a keel when you just start to feel some resistance.






While I'll agree it's better to err on the side of caution, my experience with inflateable keels has been same psi as tubes. Perhaps different manufacturers? This is from Achilles site:

Problem:
My boat floor flexes when getting up on plane.

Solution:
Check the air chambers to make sure the boat has proper pressure. If your boat has an inflatable keel, check that as well. The pressure in the main tubes and the keel should be 2.8 PSI. If you have a high pressure drop stitch inflatable floor, it is important that the floor is also properly inflated. The proper pressure for the floor is 8.7 PSI. When a boat is under pressure, the floors will flex or the bottom of the boat will have more drag causing the boat not to perform properly. The best way to check the pressure is by purchasing an air pressure gauge that gives an exact pressure reading.

Edit: I also believe the valve, called a "check valve", will not allow more than 2.8 psi in. That's why the hose pops out of the valve and/or the foot pump won't "pump" (compress) when proper inflation is achieved. But do use some judgement........
 
Smith,
I blew past a lot of the posts above so I apologize if I am duplicating anything that has already been said.

Yes, we have had 2 dinks with inflatable keels that were a SEPERATE piece. I forget the boat makes. Anyway, place the deflated keel on the centerline of the hull before you install the floor. There should be a cut-out in the floorboards that will allow access to the valve on the keel. Once the boat is assembled and the tubes filled with air you can inflate the keel. The keel will make a big difference (improvement) in the handling of your dink.

Good luck!
 
SC,
Heck of an introduction and welcome, huh?

Welcome aboard.:D
 
Originally posted by carver 2557

SmithCreek:
HOGAN is very well respected on this forum and has a vast amount of boating knowledge...You on the other hand have only had 2 postings..I would walk softly and you will get the help that you are in search of..Getting knowledgeble boaters on this and any other forum pissed off will get you nowhere.

In this case your Mr Hogan is wrong inflatable keels are not built in Mr Hogan may have a vast knoledge but in this case his post was wrong and He came off as a ass IMO
vast knowledge ? or know it all ?? sure I but don't post here much My self but I think You and Hogan owe mr Smithcreek a apology
quote]
 
Inflatable keels are in most soft bottom inflatables and both push down on the fabric on the bottom of the inflatable, and upward on the floor--either plywood, aluminun, slatted vinly or inglatable floor. The inflatable keels are usually inflated to 1.5 to 2 PSI--and may give a slightly upward bow to the inflatable floor vinly floor, which are more flexiable than the plywood or aluminum floors.

If you do not have the inflatable keel in place, it will be hard to get the boat on a plane.
 
Back
Top