Propeller Suggestions

glenncal1

Member
exMember
Joined
Sep 9, 2006
RO Number
23116
Messages
593
Hey Guys-took my new to me 1988 235 Weekender (approx 3800 lbs.) out for the first time today and could only get about 3500 rpms out of the engine and about 26 mph (GPS). Have an AQ231b and SP drive with 15x19 prop. According to the VP web site the lower pitched props they suggest are 15x17 or 16x15. I am in the Denver area so high altitude. What do you guys suggest. Thanks
 
Props are a science. I Just bought a 07 21 ft bowrider,5.0/Alpha, that weights 3400 dry and hold 50 gals fuel. It came with a REV4 14.65x19 ss prop.
I wanted an alum 4 blade for the waters I boat in and I wanted to get above the 4600 rpm wot reading. Spec is 4600-5000, top speed was 46 mph. A good prop shop will let you try a selection of props if you don't damage them.I tried a Solas
14.5x 17 first. Jumped on plane but blew through the 5000 rpms max by alot. Next went to a 14.25x19. Ended up good at 4900 rpms and change and 52 mph with 1/2 a load. If your engine is reaching wot, check linkage, than experimenting with props will get you where you want to be,its just guess work otherwise.
 
Figure that you will gain 200 RPM for each 1" of pitch you decrease. The rule of thumb for an elevation of 5200 feet would suggest that you would lower the pitch 3"--That should get you up to about 4100 RPM--4300 with the 15" prop . Right now I suspect that you are lugging the engine. There is also a rule of thumb that you loose 3 to 3.5% power for each 1000 feet of elevation--which means that you have lost 15 to 18% of your hp, assuming that the engine is still "like new"--since it is an older boat, it probably has lost more, due to lower compression. You might consider changing carburator jets if that has not already been done also.
 
"You might consider changing carburetor jets if that has not already been done also."

This could be the entire problem if the boat is new to the Denver altitude.

Did you do a sea trial before buying the boat? How did it run then? Was the sea trial at the Denver altitude? Have you talked to the previous owner?

G
 
Hope your old prop was greased! Your RPMs are exceptionally low.

Any chance you can weigh your boat and see if it is waterlogged?

(compare to factory specs)

Don't know about the altitudeadjustments and if it is necessary.

Check your throttle linkage as suggested.

Is throttle opening all the way? Is your timing advancing? Is timing correct?

Fuel filter need changing? Hard to believe prop wasn't a problem before now......

John
 
Looks like there is a carb issue, someone monkeyed with the linkage and I was getting nowhere near full opening. I have ordered the proper parts and had rigged up a temporary fix just to test the boat.
 
Back
Top