replace boat gauges

wannasail

Member
Joined
May 31, 2005
RO Number
17606
Messages
24
I have an 2355 Bayliner Ciera 1995, and want to change all gauges . rpm, mph
, oil, water, gas, volt. can i just switch them out by removing old ones and just connecting new ones and its done or do i have to do something else . Gonna use Teleflex package to replace original in boat. i have a 5.0 305 I/O
 
If you are simply replacing old with new of the same make and model, it is just a "plug and pray" operation. ie: replacing a Faria tach with a Faria tach, just unplug old and plug in new.

If you are replacing analog with analog, it is likely a "plug and pray" even with different brands.

If your engine is rigged for analog, and you want digital, see a pro.
 
I can't give you the specifics on fitment for your Bayliner, but go to the Teleflex website and get the toll-free customer service number to call in the morning. I've talked to them before and they are very good.

I can attest to the quality of Teleflex instruments after installing a full set of Teleflex Heavy Duty Series instruments on our boat. It's very good gear. You can get Teleflex at a great price through BoatFix.
 
I did all of mine last year, two engines worth. I replaced with Teleflex, had the oil pressure gauge go bad and they covered it under the one year warranty. It seems that all the connections were the same except one. For that I had to make a new harness consisting of spade connectors rather than the stud and nut.
 
I just put a whole new set of Teleflex Sportsman guages in my 84' model boat this season. Everything was plug and play as you say. I also talked with Teleflex tech support about a couple things I was unsure of. They answered all my questions and were very helpful. They are top notch in products and service as far as I can tell. I did have to take a dremel tool and make the existing gauge holes slightly larger for the new gauges to fit into. But it was soooo close, I think the sizes must be standard. Note: I did discover "after" putting in all new gauges that some still didn't work. Turned out I had a bad fuel tank and trim position senders. So just because the gauge doesn't work doesn't mean the gauge is bad. Good Luck.
 
I swapped out the gauges in my last boat-a 1987 Wellcraft 192 classic. The original gauges were what was referred to as "inverted hockey stick" gauges, and they sucked. I swapped them out for Teleflex gauges-and it was as simple as connecting the existing wires to the new gauges-everything worked, and worked well.
 
Back
Top