Stainless fasteners

That's good news Joe! It's always nice when a boat project goes better than expected.

There isn't much in the boating world that I know a lot about but if I can shed some light
I like to help.

I've picked up so much from this board that's helped me on my boat projects I feel that I
owe you guys anything I can give.

Thanks,
Pete
 
What Gami says is mostly correct but the magnetic properties should be further explained in case someone gets "magnetic" 300 series or slight rusting of the stainless.

All the 300s are non-magnetic when annealed. That is, they should not show any magnetic permeability which means they should not react to a magnet or affect a compass. Most 300s, especially 302 or 304, go thorugh a phase trnasformation when cold worked. Even if just hit with a hammer. One of the constituents that trnasforms goes to "pseudo martensite" which is essentially 400 series stuff which is magnetic. If you balance the alloy ingredients just right, that won't happen. Such a balance doesn't happen in the real world so we add some molybdenum to artificially stabilize the 300. This is the alloy called 316. As stated by others, if you also keep the carbon low you avoid carbide precipitation. That's important if you're gonna weld the stuff.

That pseudo martensite also rusts. Thats why some bolts and screws get real nasty looking. They weren't the desireable, and more expensive, type 316 stainless.
 
If you go to this site: http://www.mcmaster.com/ you can type "stainless steel screw" (or bolt, nut, or whatever you want) in the search box.

When the choices come up on the right, in most cases, you can choose 18-8 or T316 and buy whatever you need in the alloy you want. They come in boxes, so you can't buy one's and two's, but the quantities aren't overly high.

We use SS fasteners all the time at work and found this to be a great source when we need fairly small quantities.
 
18-8 was the early designation for type 302/304. T316 (or type 316) was once called 18-8-Mo. A couple percent of molybdenum does wonders for stabilizing type 302/304 and preventing the little rust stains you occasionally get from "stainless".
 
Back
Top