the loop???

Wish you well with your Loop plans. Years ago we had plans of getting a 38-43' trawler to do the waterways of N America. There are many variations of the route to choose from. Many folks forget the Trent Severn Waterway from Kingston ON to the Georgian Bay. Also there is the Rideau Canal running from Ottawa to Kingston. These systems can handle surprisingly large boats.

Our trawler plans sprouted wheels 2 years ago. Those wheels have spun in 40 states & 5 provinces so far. Any time we get the boating itch, we rent or do a cruise. We are currently enjoying the fall colours in Bar Harbour, ME.
 
hey Capt bill its a foam rubber sided covered in marine vinale (sp) thats 4 foot across and hols about 100-150 gals. We put it on the back over the engine covers which have been strengthen to hold the weight. I'll try to find the web site for you and post it on here. We love the thing.
 
I've seen an ad for those, or ones like them. Always wondered how well they work.

You would need at least a 300 gal. per day water maker I would think. Just because much smaller and it would be running 24/7 to keep up.
 
Watermakers: First they are expensive. $5000 or more. They have to be back flushed after each use. If you contaminate the membrane with oil, chlorine, jelly fish--they are gone--min $400, on up. If not used at least once a week, they have to be cleaned and pickled (preserved). They should not be run in harbors where there is chance of oil, waste or sanitary (fecal) contamination. They use a fair amount of power--although there are even 12 volt units, all of the ones I owned used 220 volts. It is cheaper and easier to carry extra water; even a bladder tank. As for the hot tub--use either water from the dock, from the bay (and rinse out the heater after each use). But I'll bet you will not use the hot tub much on a loop trip. Just too much trouble. Even with a water maker water is relitatively expensive--figure generator run time, wear and tear on the genset and watermaker. a 250 gallon a day water maker makes ideally 10 gallons an hour--I have had 500 gallon a day watermakers--far more practical--and that way you get 20 gallons an hour. You want to keep generator run time to a minum. (Noise, fumes, etc) On our passagemaking sailboats, we made water, cranked out a couple of hundred amps of 12 volt battery charging, cooled down refigerator and freezer holding plates, heated water, did laundry, etc all in running the gen set 2 hours a day.
 
If you really want to do the loop, you will do it with what ever boat you can find. Your 1990 30 foot Carver Santego could do the loop with ease--an more luxury than many boats which do it each year....even without a stall shower. You might have to go at displacement speeds in some areas, to get the range.

I looked up the hot tub link. It says that it only uses the heat from the motor--no specific heater. That does not sound as if it would practical to dump the water and then refill it--even if it was wise to have a full hot tub (100 lbs for the tub, plus 140 x 8--over 1200 lbs extra weight in the cockpit--I understand re-enforced--but might put some scuppers too low and cause potential back flooding to the engines.

There are people who talk about doing voyages, there are people "trying to find the right boat" and there are people who just do it! The costs over all might actually be less with a gas boat you already own, than buying a bigger trawler, and taking a hit on the resale, taxes, commissions etc...just do it.
 
While I don't agree that watermakers are that big of a maintenance issue, I do agree with everything else Bob has mentioned.

A watermaker just to keep a hot tub filled is heck of a waste of money. But hey, it's your trip and your money. :-)
 
We have a 900GPD automatic sea recovery on Charmer which is all automatic, incl a weekly back flush. no maintenance beyond strainer and filter (until electronics and sensors start acting up with age) but so far filters have been a major PITA because of plankton up here in the north east. The plankton filter needs to be cleaned and the 5 and 25 prefilters need to be replaced way too often.

like everything else on a boat, your watermaker has to be sized for your needs and lifestyle. typically, you want to run the genny just 3 or 4 hours at night so you need a watermaker that's big enough to make the water you need in that time frame. If using a smaller DC unit, which may work on the loop since your run the engines for extended time, it needs to make enough water during a x hours of average run time and your alternators need to keep up. Those high pressure pump use a lot of power!

my slip neighbor has a soft tub on his aft deck and he's happy with it. One issue when cruising is that it takes a while to heat up a 110v hot tub (soft tub or regular...) so by the time it's filled and hot, it will be past the bed time of most cruisers :-)
 
ok thanks for the input guess it sound more like a PITA than it worth. I love the tub but we'll see if theres enough room after we pack everything else.

Thataway4 We are going to just do it just not this year since we live on the west coast of Fl and were thinking about leaving around january to head south and east to the Bahamas then head north on the icw... just wannna start preping now. Everyone know an ounce of prep is worth a lb of happiness on a trip like this one....:)
 
we looked at one for around 4500.00 that makes around 200 gpd I think...could be wrong it was at the Tampa boat show and we looked at alot of stuff while there
 
Back
Top