Using connecting links ??

airbus

Member
exMember
Joined
Sep 7, 2007
RO Number
28518
Messages
270
Just got two connecting links to add some chain to my hook, but not sure how to use them.

The two side fit together, a little pins go thru little holes on each side.

It looks like maybe you hammer down the pin flat, but I'm not sure.

Has anyone used these?

connlink.jpg


Thanks.

AB
 
Those pins are rivets...

Assemble, putting the pins in and arrange with the head of the pins down, on a very hard surface ( like a scrap sheet of plate steel). Then use a flat face hammer hammer to expand the protruding tip of the pins. Then use a "rivet set" to crown over the tip of the rivet.

Some people just whack them with the hammer...

There are likely other methods...
 
quote:

Originally posted by Radioactive

Those pins are rivets...

Assemble, putting the pins in and arrange with the head of the pins down, on a very hard surface ( like a scrap sheet of plate steel). Then use a flat face hammer hammer to expand the protruding tip of the pins. Then use a "rivet set" to crown over the tip of the rivet.

Some people just whack them with the hammer...

There are likely other methods...






Thanks for the advice.

I couldn't find a "rivet set" nearby, so I used a hammer to flatten it a little, then found a 6" bolt that had a concave indentation at the bottom that worked perfectly as a punch to crown the top. Actually worked quite well.

It turned out great, so thanks.
 
Back
Top