Zincs

ALKA2710

Member
Joined
Mar 5, 2007
RO Number
25407
Messages
670
Just finished painting my out drives for the year with anti-fouling paint. When I put the new zincs on do they have to make contact with an unpainted area of the drive or can I put them on over the anti-fouling paint. I think I know this one but do I have to scrape the paint off of the grounding tab on a alpha drive before I bolt it back up. Thanks
Al
 
If the antifouling paint is copper based and your outdrives are Aluminum alloy, and you did not apply a barrier coat, you may cause a great deal of corrosion to the outdrive legs.
 
Sorry I should have gave the whole story. Factory finish was sanded and coated with 2 coats of primacon and then 2 coats of trilux 33.
 
Regardless of type paint......zincs or anodes must have direct contact with unpainted metal.
 
The anodes ("zincs") need to be unpainted, but I'm not sure the area under them needs to be unpainted, as long as the unpainted bolts make contact. Isn't the unpainted fastening bolts and bolt holes enough of an electrical contact?
 
Do not remove the paint under the zincs - as Glenn says - the contact made through the bolts is sufficient. If you are in salt water you may want to consider using aluminum anodes. If in fresh water magnesium. You should also leave a strip about an inch wide on the transom where the O/D housing comes through. This insures that there is no current from the copper in the boat's bottom paint and your o/ds. I usually over spray that area with Trilux (no metal content)
 
Back
Top