Abaltive Paint???

Finally found some info on the Interlux site about the Epoxycop abaltive paint.

"Epoxycop® Ablative

The all purpose ablative antifouling paint ideally suited for cruising and powerboats that desire good, dependable protection at a competitive price. Epoxycop Ablative is resistant to algae, barnacles and other marine fouling. It is compatible over all types of properly prepared bottom paints and surfaces (except aluminum). The Epoxycop Ablative formula enables easy cleaning with minimal paint build-up. Excellent performance in high fouling and tropical waters.

* Ablative antifouling for Power and Sail wears away with use
* Minimal paint build-up with easy cleaning
* Can be applied directly over most properly prepared bottom paints
* Dependable season long protection in all waters"

http://www.yachtpaint.com/Images/15_25967.pdf

Definitely indicates "season long protection" but I get several years out of it with no problem.
 
Last Spring I put on two coats of Petit Ultima SR which is comparable to Micron Extra. It held up well with absolutely no fouling. I probably need to touch up a few spots this spring before I launch but I will get the two seasons out of it as advertised.
 
rommer...thanks for looking that up. I think I will try it over what every I have on now.
Niles
 
One other thing I noticed with all the Interlux paints is that most say that you need 2 to 3 coats.

Here is the info from the micron extra with bilox, "Number of Coats: 2-3 minimum"

Seems one coat is not enough as per the manufacturer.
 
Yeah, that is why i did a orange signal coat of biolux.
Then a black coat. So I had 2 coats, but not the same color.
My results were very good.

You know except for running gear, I don't think I have ever seen a barnacle attached to a boat.
I think paint is over-rated. Seems as long as you use your boat, the growth stays away.
 
John, I have been using Epoxycop Ablative for the last 4 seasons with the same results as you, except I repaint yearly. I have yet to see any growth come the end of the season.
On my sons boat, I get 2 years without any problem.
 
I had the same question about bottom painting when you don't know what's already on the boat. I sent an email to Interlux and this is their reply....Unfortunately if you do not know exactly which bottom paint is previously on the boat I would recommend either stripping the bottom paint or priming the paint with Primocon. This will guarantee no adhesion problems. However, If came from the factory, painted, it is most likely a basic hard antifouling paint. Most hard and ablative antifouling paints are compatible with Micron Extra just by sanding with 80 grit sand paper and cleaning contamination off of the surface with Special Thinner 216. The Micron Extra with Biolux will be a great choice for you because of the added biocides in Biolux which will protect against slime and algae. Hope this helps.
 
Back
Top