Anchor Locker Leaking

BillK

Well-known member
Member
Joined
Jan 1, 2000
RO Number
775
Messages
1,226
So my wifes sister and kids come to the lake for the weekend. We are out for a cruiser today, slow, 6 people on-board. After about an hour we get back to the dock and I notice the bilge pump is running. On inspection I find that water had been coming in through the anchor locker drain. This is an 18ft bowrider with a small locker. The drain is just a hole through the hull neer the bow eye, and has a stainless steel cover over the outside (typical cover you see on almost all boats). It's unusual for me to have that many people in the boat, so the bow was down and allowed water back through the drain. Is this common? I'm thinking about sealing the drain somehow, as I really do need a drain in the anchor locker on this small boat. I was suprised to find a whole straight through with just a small cover on the outside. If this doesn't make sense I will try to post a picture later.
 
If you seal the drain hole, what is your plan for removing the water from it when you wash the boat or if it rains. I suppose you could keep a sponge on board and do it that way. As I think about it, that is probably the way to go.
 
Are you sure the water entered through the anchor locker? How did the water go from the locker to the bilge? Maybe this is the route you want to make the primary drain which could allow you to plug the bow drain.
 
If you are up on plain, it seems hard to believe that the drain could be below the water line. If you are front heavy and just plowing water I could see it happening.
 
The anchor locker needs to be sealed off from the bilge of the boat. It sounds as if there is a defect, which allows any water which gets into the anchor locker into the bilge of the boat.

You should not seal this drain hole--it is necessary. But you should seal where ever the water is doing from the anchor locker to the bilge.

With bow riders, you have to be careful of the trim--keep the weight back, so that water will not come in thru the anchor locker.
 
This was happening at slow speed, off plane. I just had several people in the bow section. The anchor locker does not appear to be water tight, water seeped between the locker and the inner liner that forms the seats in the bow section, then made it's way into the bilge. I guess on the larger boats I have had it's not an issue because 1) the drain is much higher above the waterline and 2) the locker was sealed. I have never really looked at these, but is it common to just have a hole covered by a stainless steel cowling? No huge thing, but now I know how water is always getting the the ski locker. See picture.

a9aa2238.jpg
 
I had the same thing happen on a Searay 260BR. At slow speeds the bow wave would rise up over the anchor locker drain and fill the locker. If the locker got full enough it would overflow and run along the side of the boat to the bilge.

I finally found a small one-way check valve and installed it inside the anchor locker. This blocked water coming in but allowed water to drain out of the locker. If you do this you need to make sure you get a valve with an extremely low cracking pressure so that only a small head of water is required to start the outward flow.

Mike
 
As soon as I read your first post I knew what was going on with your locker, have seen that un-sealed installation many times. You were very precise with the slow speed and additional passengers, good rendition of events.

If you seal a tube into that drain hole and run it down past the opening in the SS shell type fitting a bit (not facing forward), that should eliminate the problem. When in motion you will be creating negative pressure and not forcing water into the compartment. Of course, if you install it facing the bow, you can fill the boat up in no time :D
 
i'd be concerned about an anchor locker which is not sealed to the bilge. there has to be a way to seal it
even if it requires some glass work. the reason lockers have drain is that water alwways come in from rain
or splashing so you want that to drain, not get in the bilge.
 
Thanks everyone. Pascal, I agree that the best approach is to seal the anchor locker. I need to look closer, it might not be as hard as I think.
 
Yes, the SS cowl vent cover is the common way to cover these drains. It would make much more sense if there was a baffel to prevent water from comming in from the bottom--but that costs more.
 
quote:

Originally posted by thataway4

It would make much more sense if there was a baffel to prevent water from comming in from the bottom--but that costs more.





Especial since the opening so near the waterline. Mine is a good +foot above the bow's waterline!
 
Back
Top