big go fast??

rgy

Member
Joined
Apr 24, 2002
RO Number
8311
Messages
178
I live near the skater factory so I assume this boat was a skater. It had a very large beam so it was on a trailer that tilted the boat about 45 degree angle. I assume the trailer is hydraulic for loading and unlaoding, correct? If not, can some one "splaine" this to me?

tugboat Kevin, do you have a video of one of these trailers?
 
charlie, it's tilted sideways so the starboard side of the boat is 14 or so feet in the air. It barley cleared the traffic lights. the boat probably had a 15-16 foot beam. Seems like it would stress the pontoons something fierce.

here's a pic.

http://tinyurl.com/428k2u
 
HAAAAAH! Now that's a new one.....I 'spect it's for transporting on the highway.
 
Yes they tilt them so it is at the legal width for trailering. Besides the tilt trailer the boats have pumps to remove the oil from the engines and then replace it when the boat is level. As far as stressing the hull .... being a Skater, I
wouldn't worry about it. <g> I prefer Vee hulls over Cats but if I had the cash I could be real tempted by a Skater. Extremely well built and designed.
 
They have been moving race boats in this fashion for decades.
As a kid I remember seeing unlimited Hydroplanes traveling to Madison WI (yes WI)the same way.

The boats are too wide to travel normally accross highways.

Jim
 
At the Offshore Races I've seen they load/unload them with a crane.
 
there is another picture on the skater web site showing the other side and all the hydraulic pistons. so i would assume when the boat is layed flat you could launch and load from any ramp. I didn't see any cut outs in the bunk for straps.
 
Back
Top