blocking a trailer

sea J

Member
Joined
Dec 8, 2006
RO Number
24485
Messages
7
what is the best and the safest way to block a trailer and take the wheels off for the winter?
 
You don't have to remove the wheels. Get a hydraulic floor jack and raise one wheel (two if tandem) just clear of the ground. Place a pair of jack stands preferably under the axle. Lower. Repeat for other side.

The idea is to just take the majority of the weight off the tires.
 
If you leave tires on trailer, cover with dark poly sheeting or other materials to block sunlight - reduce UV degradation of the rubber. Also, block my trailer with 4"x4"s under each axle (tandem axle trainer) front to rear, inside frame just behind tires and use cinderblocks to support - lot of work, but will withstand some fierce weather conditions.
 
I also recommend the cinderblock and pressure treated support method under the axles... once the wheels are off the ground hose everything metal around the wheel area with wd 40 then coat the tires with armourall then cover each tire with a heavy duty trash bag... also wd40 and grease the trailer hitch area, bolts, brake couplings...etc
 
Depending on the weight of the boat you may be able to just lower the tongue to the ground, block up the frame as close as possible to the rear of the axles, then either use the trailer jack or preferably hydraulic jack and blocks to raise and be able to block the rear of the tongue enough to have wheels clear the ground , then block frame at rear of tongue and just in front of the axles. That's 6 blocking points, 3 each side for even support and it worked nicely for me. Make sure the support is even so as to avoid putting a rocker or hook in the hull and support of keel at the transom can be important. If cement blocks are used, make sure there is PT wood under & over and the block holes are vertical for correct strength. Very important to have the keel pitched enough to insure very good bilge drainage through the garboard drain , not just through cockpit sole scuppers.
 
Pressure treated lumber or automotive type jack stands are good for raising a trailer off it's tires. Cinderblocks are not so good, they can crumble from the weight unless you find a way to spread the load.
 
Back
Top