I am just having my bow thruster installation wrapped up this week. I have a Mainship 40 Sedan Bridge. If you are a member of the Mainship board I have posted pictures over there. I am using a Vetus thruster. My installation is similar to the link posted above with a few exceptions, I had to replace my old 43 gallon aluminum water tank with a smaller 35 gallon Poly tank, install the new battery charger for the thruster batteries, install a new AC circuit from my main panel to the new charger, relocate the AC unit and ductwork. Then a new floor was glassed in over the tube under the berth and painted. I also went with 2 large AGM batteries to power the thruster. I had the installers run 1/0 red and black from the batteries to the ER where eventually I will install the largest BlueSea ACR for charging off of my alternators. All high current thruster/battery wiring is 4/0. Regards Bill