CAT 3126s

Andy, that's my understanding too: 1.1 x 6 cyls vs. 1.2 x 6 cyls
 
I was going to send an E mail to the origional poster, with an excellent quote on surveys from another list--but since I have lost my anchor, I cannot do that. The essence of the post, is that you better have one very very good hull surveyor, one very very good engine surveyor and one very good boat driver to go with you on the survey. Plan on spending over $1500 on all of these, and take their words. In this case, a boat which was supsosed to be in "perfect condition" and was selling for $187,000, needed $147,000 worth of work to make the boat "right". The person walked on that, and purchased another high end boat, using the seller's surveyor and mechanic--the repairs on that boat cost him only $60,000! The buyer was an extremely knowlegable yachtsman who already owned several boats and had been boating for many years.

This buying a used boat--even "Lightly used" with low hours is frought with risks of repairs. It is far better to spend a few thousand and get very good advice than many thousands later!

At 8 knots you should be getting about 2 miles a gallon--but it may be slightly less.
 
quote:

Originally posted by kindredspirits

dominic....to my knowledge, when Cat started production of the 3126 they were electronically controlled injectors from the start. This is what differentiated the 3116 line(with mechanical fuel pumps) from the 3126. Cat has recently introduced ACCERT technology(emissions)........this started the "C" series engines. You would be correct in saying that the 3126 has "evolved" into the C7.





I can asure you that the 3126-TAs are NOT electronically controlled injectors. I have two and they are defintely mechanical. The 3126B/C7 are HEUI (Hydraulic Electronic Unit Injection).
 
dominic...we produced the 3126B in the following serial # prefix's....3GS & 9ZF. Both were HEUI systems?????? If you had an earlier serial #, possibly a 8NM or a 6SR, these would have had a unit injector fuel pump(mechanical). After the 9ZF we started production of the ACCERT C7, which would be a HEUI also. Now you've got me curious.

Chris
 
Chris......My 3126-TAs are 1ZJ and they are MUI..Mechanical!

Who is the "we" you mentioned????
 
To mimic Dominic - my 3126 TA's are also mechanical and serial #s begin with 1ZJ also...
 
The casting problems mentioned above were engines built through 1995 or very early 1996. I had 1996 engines (late model year) and the only problems were several injectors had to be replaced. Also, the Cat dealer recommended running straight 30 weight oil and claimed 10W-40 was bad for the turbo (not enough flow). They were very economical engines.
 
Back
Top