Clunking into gear??

Johnblack1

Member
Joined
Jun 7, 2007
RO Number
26679
Messages
4
I bought my 1995 maxum 1800SB (4.3L V6, AlphaOne) last May and it only had 327 hours. Rode it a little less than 100 hours last summer before winterization/oil change/outdrive service/gimmel bearing replacement. We do moderate tubing/skiing/wakeboarding. 3 quick things: 1)since I got it, when I put it into gear in the water, I get a pretty decent"clunk" nearly everytime and that's forward and reverse. It runs great in gear and I've had no problems. 2)with skiing comes a lot of starts and stops, but when I go into neutral, it seems to stall about 70% of the time. 3)Just this year, I've had it out 4 times or so. When I turn the key off to pick up a skier, it's been sputtering and not shutting off right away. Sometimes I have to turn the key back on for a sec. and then off again to get it to shut completely off. Let me know if I need to give more info. thanks, Great Forum!!
 
1) Clunk is normal with Mercrusier's dog type clutch. Not to worry.
2) Could maybe use an adjustment on the shift interrupter switch. This momentarily kills the engine so shifting is easier.
3) Could be a timing issue, or a carb adjustment problem. This was a common problem with those engines, one work-around would be to let the engine run at idle a bit before turning it off.
 
I have the same engine/outdrive etc. According to my Master Certified Merc mechanic,

1) that "clunk" is caused by not shifting quickly enough. Shift more sharply and avoid the clunk. That clunk chips away at the teeth in the gear and will wear it down. You can't ease these Mercs into forward and reverse!
2) this might be caused by worn teeth; see #1)
3) have a good mechanic check it over. Do you have towing insurance and a VHF radio?
 
You got pretty good advice so far. A little to add, set your idle as low as your engine will allow you to. The higher the idle, the louder the clunk.

Secondly, a high idle will increase your chances of dieseling when you turn off the motor.

The 4.3 is also known to diesel if turned off right after a hard run because the combustion chambers are hot. Let the engine idle for 5 min before turning off, to let the engine cool down. There also may be a carb adjustment to the problem(running too lean) bit don't worry about that yet.

Engine dying when trying to shift into neutral could be shift adjustment or sticking/corroded lower shift cable. Look for cracked/split shift bellows. That's the small diameter tapered rubber boot thingy on the starboard(right side) of the drive, between the drive and transom assembly.

Let us know what you find.
 
Have to agree with most of the respones. Shift swifter, the clunk is normal. Dieseling is because the engine is hot and it needs to idle for a few minutes. Do this and it will solve the dieseling problem. The stalling going to beutral sounds like the shift interrupter, but could be something else as well.
 
Back
Top