Hamster, I have been running MM for over 30 years. First an Atlas 215, then a Icom 820, a Kenwood TS140 and recently an ICOM 7000. The most important part of a maritime mobile rig is the ground. Antennas are fairly easy, and I favor Ham Sticks. On small power boats, I fit them to a hand railing with a "mirror mount"--and then ground the railing, using the 2" to 3" copper foil as WirelessOne refered to. Then running the foil to a ground point. In an I/O boat you can use the lower leg--just be sure that there is no insulation between the point of attatchment of the ground strap and the leg itself (ie rubber or plastic parts). I found very early that wire or muiltistrand ground strap did not work well, and there was RF in the boat.
Some people just take the ground strap to a thru hull fitting (has to be bronze)--but in the larger boats I use a ground plate--the small boats I own now, just the outboard or the Armstrong Aluminum bracket that the motors bolt to. I have also used solid hand rails as part of the ground system, bridging each with copper strapping. When attatching the strap, I fold over the corner 3 times at 45 degrees, to give good thickness and then drill a hole through this point and bolt it to the radio/tuner ground. If you go with the 23 foot whip, any wire from the tuner to the whip is part of the antenna--and needs heavy insullation, plus should not run parallel to any other metal objects (especially the ground strap).
Have fun! 73's de KA6PKB