Davis Mega-Light: LED array bulb replacement

I was able to log on today, so if there are any other questions that my email to Dan didn't already answer, I'd be happy to help.
 
Welcome to the boards, Jeff!!

I've already ordered the Marinebeam replacement bulb so my question might be a bit late, but here goes. Does the Marinebeam replacement bulb meet all USCG requirements for anchor lighting and carry USCG certification for use in the MegaLight?

Thanks
 
Al,

The fixture carries the certification, not the bulb. The mfr submits the fixture with the light source to a certified lab and they test it against the ISO standard for output, color, viewing angle etc. If you go down to West Marine or Walmart and buy a suitable replacement bulb, that bulb has no certification as a standalone bulb. Same with our bulb.

We recently did a pre-test of our big anchor light bulbs with Ensieta, the French navy labs, within the Aqua Signal fixtures, so I am familiar with the specs, regs, etc. This bulb is significantly brighter than the factory supplied Mega Light bulb, and the bulb itself has the luminous flux (90 lumens) to far exceed the requirements for visibility at 1nm and 2nm. Obviously, a bulb manufacturer has no control how their bulbs are used, so we make no claims beyond its ability as a stand-alone light source.

We could theoretically have the Mega Light fixture certified with our bulb, which would cost about $3,000. Unfortunately, then we would have to sell the bulb at a much higher price, and we would still not be able to claim that the bulb itself is "Certified", and we would have to sell the fixture with the bulb to be safe (as there are knockoffs of the Mega Light), which would defeat the purpose of having a replacement bulb! Catch 22.

Cheers,
 
Al,

It turns out that my late FIL made the installation more than 15 years ago on this 40' boat.

DSC00877.jpg


The fixture is an extendable base mast all-round light mounted on the bridge. He simply removed or hacksawed the old light from the top of the mast tube, made electrical connections as before, wrapped the threaded base and strain relief of the Mega-Light with closed cell foam rubber and electrical tape and push fit the Mega-Light into the end of the tube. It's been there for at least 15 years and still works.

The only thing I would do differently here is add some 5200 or a softer polyurethane sealer to seal out moisture, but the FIL's method seems to have remained water tight all these years.

Checking out this installation reminded me of this:

Important Note: There are three models of the Mega-Light. Use the Mega-Light Masthead model if you want a hard-wired installation. It comes with 12" of wire for hook-ups. The Masthead model is shown in this post.

In my orginal post you can see that my Mega-Light looks a little different. It has a gray plasic base. This is the Utility model and it comes wired with a 12-volt plug. The cable on the 12-volt plug models of the Mega-Light have very tiny gauge wire that is more difficult to use for making electrical connections.
 
Thanks, Dan. That helps a lot. Looks like I ordered the right one. I like these kind of projects, too. A little ingenuity, simple skills and fast and significant results.

Jeff, Thanks for the explanation. I got the MarineBeam lamp in the mail today. That was fast!
 
Back
Top