Dock suggestions

mx8

Member
Member
Joined
Nov 28, 2006
RO Number
24359
Messages
600
I`m looking for some input from those who have been involved with dock installations. I am starting the process of researching and designing/decision making on putting a dock at our house.
Factors: we are on the Connecticut River, tidal, 3 knot current in both directions every day. 5 knots southbound a couple times a year. Direct exposure to the channel, there will be serious wakes, lets face it, they won`t slow down.
Ct Dep says it a relatively quick permit process ( although I don`t think "quick" and " DEP permit" should be used in the same sentence) if I can get away with two pilings at the low tide line w/ 100sq ft of dock.
The water gets deep 10` off the low tide lie so a tee dock would work well (IMO) 3` wide, 10ft out, 23 ft. across the tee= 100 sq ft.
The question is what type of dock would hold up to the abuse of the current and wave action/ I`ve been looking a www.ezdock.com Any feedback or suggestions from members with experience are welcome. I plan to use it for a small boat, 15 to 22 and a watercraft for now but obviously I would like to upgrade it enough to handle the 40`. I could almost pay the entire prject with one seasons slip fees.
 
if you get serious wakes, the only safe option maybe a lift.

depends how serious... forget fenders maybe, just maybe, mooring whips will do or a pair of pilings to keep the boat off the dock, with long lines and rubber shocks

not sure if floating dock/lift will be able to handle the wakes.
 
I agree with Pascal - I would really look into a lift with the tide and current your facing...

Perhaps someone with more experience with an EZDock will chime in. I think a fixed dock with a lift would be the best option.

A few years ago I went through the process of installing a dock. It's fixed - sitting on 6 pilings altogether. All steel structure - with treated lumber through bolted for a base, and then Timbertech for the surface (to reduce maintenance).

I would also think about running at least shore power and water while your at it. I also included cable, phone, and a network drop.

Here is a picture:

IMG_0395.JPG


Good luck - it should be a fun project for you!
 
MX8, Save yourself the trouble and install a boat lift,for a small boat look at a 6K lift :http://www.boatliftdistributors.com/point-boat-lifts-aluminum-boat-lifts-c-21_28_43.html
Never worry about boat traffic,dock line's ect,after keeping my Scarab secured with whips & oversize fenders for years,finally got a lift ( IMM Platinum) life is good. said and done final cost with electric/piling install/assembly ect 10K
 
We have a 145' pier with a 'T' and 4 slips. One has a Jet Dock that is built for a 22ft bow rider, and I've had great success with that, but as others have said,,,a lift is your answer. Also our pier has pillings that siick up past the pier every spot, and I think I feel safer with something to grab if necessary, and also something to tie to. We are 6ft wide and have mostly 9 to 10 " pillings. btw,,the Jet Dock was more than a lift for that size, but didn't require power. We now have full power and water to end, and make sure thast is a goog install due to any high water you may get.
 
What is the tidal range, ie difference between high water and low water? I would think a floating dock might be your answer. You might want to go a little wider then 3' for stability, but that means a little shorter dock. A piling at either end of the dock would keep the dock where you want it at all times. You could also put the ramp at either end of the dock rather then in the middle, then if the is enough water you could also dock a small craft on the inside of the dock.
 
I don't think you will be putting a 40' boat on a lift. The boat needs to be held off the dock no matter what. A couple of hold off moorings, bow & stern, should do the trick. No need to float them (mooring balls). Everything is controlled from the dock.
 
The tidal range is around 3 ft. The lift is fine for small boats but like Vee says I don`t want to get involved with it for the 40. The solution for the bigger boat(farther along in the process) is bow out
between two pilings at the bow cleats with spring lines back holding the stern a foot or so off the dock. Thats how its done around me and it works fine. The permit process for that is more complex so I will do that later. For now I am looking at floaters that can take some abuse.
 
You seem to have a pretty good idea on what you want to accomplish. I am wondering how far into the permitting you have looked. When we had a waterfront property in Clinton, CT we looked into building a dock (actually re-building an exisitng structure) and it looked like it would take at least a year to get approvals and would definately have involved an attorney that was familiar with the DEP permitting process.

I have seen adds for the "jet dock" system, and they usually have a disclaimer about needing a permit to install one in CT waters.

I have always wanted my own dock, but interestingly enough, a few of the people that have docks on my river (Pawcatuck) have started keeping their $300-$500,000 boats at my marina becasue their personal docks are open wave damage.

Dan
 
Ive spoken with the DEP and a dock engineer, I`ve got the folder at home with the details on the permits , I`ll respond with more details after I review it.
 
More out of curiosity, mx8, you live on the water and have a boat but you currently do not dock it at your house?

That must be terribly painful!
 
It does hurt, we just moved in late last summer and have been renovating the house, now its time for priorities! I`m going to cry next week when I write the check to the marina. (12 miles downriver) Hopefully, it will be the last one.
 
"Floaters that can take some abuse" - concrete floaters work well. Typically found in marinas, not residential docks. Bob
 
With the current, wakes and low tidal range, I would suggest a fixed dock. A 3 foot dock is narrow, but usable, this is equivilant to the fingers between boats.--4 to 5 feet far better for a main gangway, but then you may have an issue with permitting. I also would go for a lift. Hi Tide boat lifts are built in capacity up to 180,000 lbs! Boat lifts of 25,000 lbs, will handle most 40 foot express cruisers.

In the long run, you will be happier with the boat lift. Put the pilings in for the smaller lift now, that can handle the higher capacity which you will put in when you buy the 40 footer. However, check the regs and be sure that the area under the lift footprint is not included in the permited area.
 
We have lots of wake, wind and ice. Our dock holds up just fine and the boat, a 19,000 pound power boat, does fine as well. We have a 6' wide dock that is 50' long. It is built on 4 steel pipes of the sort used for high pressure gas lines. The pipes are joined by I beams and a steel frame. A nailer is installed on top of the steel so the deck can be attached to the structure. There are two slips on each side of the deck that are 17 feet wide. Three treated pilings are installed on each side of the dock. The boat is protected by virtue of a four way tie plus a spring line. This arrangement has withstood 100 mph winds with no damage to the boat.
 
O.K. I`ve reviewed the CtDEP regs, a waterfront property owner has litorral, (coastal) or riparian, (river) rights to access the water abutting the property, not much different than an inland owners right to a driveway. If this can be accomplished under their "4/40" rules, the permit process is relatively simple, no public announcement, a meeting versus a hearing,all usually accomplished in 6 months or so. Simplifying the 4/40 standards: a dock that is in 4 ft of water at mlw without being more than 40 ft from mhw qualifies. Obviously there are sq. ft limits and it can`t be in the channel, etc, I have a steep approach to very deep water so this should work. Any structure beyond these limits requires much more extensive site evaluation and I`m told the permit can take two years.
Personally, my biggest hurdle is the "Endangered species impact evalation", the bald eagles that are gliding around are off the endangered list but I don`t know if there isn`t some kind of rare salamander or something thats going to crawl by and ruin everything! Any biologists in the group?
 
Are you on part of the "no wake zone" on the river?

With the tidal drop, I think you want a floating dock, if you get hit by wakes, you need something to keep the boat from banging into the dock.
 
quote:

Originally posted by Veebyes

I don't think you will be putting a 40' boat on a lift. The boat needs to be held off the dock no matter what. A couple of hold off moorings, bow & stern, should do the trick. No need to float them (mooring balls). Everything is controlled from the dock.






My Sea Ray 370DB (over 42' LOA) was lift kept for 14 years and slip kept for the last 2 years. The former owner built a full wrap around fixed dock around the lift. It was beautiful and held the boat securely in 3 hurricanes in a single season.
 
There are 50' Sea Rays in eastern VA on lifts. I agree with floating docks. Might be worth a trip to Groton.
 
I've lived in a waterfront front home since I was 22. I'm on my third, present one since 1977.

I have a 12 wide 1990 HM 38, which I've lifted since new, in a covered boat house, boat is in great shape.

One savings of lifting is no need for bottom paint and less less wear and wear on boat and drive being dry stored. Have a problem with prop or bottom, no need to have boat hauled for inspection.

I do recommend four lift devices, each controlled separately, so leveling boat is easy. If you use only two lifts devices, one one each side, a little difference in cable winding is hard to adjust for, if not impossible.

Need to adjust level to get all water to one spot in bilge, just use the 4 point lift to get boat just right.

Mine is out 150' in 8' of water and has a 2000sf of covered area for 4 boats and 2 jet skis. Dock uses 4x4 treated and 38 lift uses 2 6x6 for each lift device, life is 30 years. This year i just started to replace dock, closed to shore, which was the first to be built before add ons.

Ice flows would have a definite impact on your design. In Houston, ice has never been a problem.
 
Back
Top