Documenting your boat

airbus

Member
exMember
Joined
Sep 7, 2007
RO Number
28518
Messages
270
I have a 330 Sundancer that I am documenting.

Where should I mount the Document Number Board, to conform with the regs.

Thanks
 
its all explained on the paperwork that comes with the documentaiton. it needs to be expoxied to the boat, either a stringer or hull. not something removable like a hatch. Mine is epoxied to the hull in the anchor locker, most are put in the ER.
 
Yup, just mounting a "board" in the bilge doesn't really comply unless it would be obvious that it was removed or altered.
 
quote:

Originally posted by PascalG

its all explained on the paperwork that comes with the documentaiton. it needs to be expoxied to the boat, either a stringer or hull. not something removable like a hatch. Mine is epoxied to the hull in the anchor locker, most are put in the ER.






Thanks for the replies. That explains what I need. I have the explanation that came with my certificate, but couldn't figure out how to properly attach the number. Just bolting it on, didn't seem to be enough, but the epoxy solution make perfect sense.

Is it ok to route the number in a wooden board, and epoxy that in some visible place in the bilge?

Thanks again for the quick reply.
 
yeah, usually cutting it a piece of plywood with a jigsaw is what most people do. i dont' recall, but i think it has to be 2 or 3" high, check the rules. then you can epoxy it somewhere visible... hull side, transom, bulkhead, etc...
 
Mine is stenciled on a stringer in the ER. USCG said that was OK too.
 
The official number, preceded by the abbreviation "NO" will be marked by some permanent method on some clearly visible interior structural part of the hull. The number shall be in block-type arabic numerals not less than three (3) inches in height.
Pleasure vessels will have the name and hailing port of the vessel marked together in clearly legible letters not less than four (4) inches in height on some clearly visible exterior part of the hull.
This info is from an official site. Read the( clearly visible interior structural part of the hull and 3in. in height.) Sounds like the engine room beckons. Good luck.
 
Mine is marked on a fiberglass stringer using a drill bit to write out the numbers.
 
quote:

Originally posted by KiDa

Mine is stenciled on a stringer in the ER. USCG said that was OK too.






So you are saying it's just printed on a stringer?
 
Mine is drilled too. I think it's from the factory because it's very well done. Paint and stencil looks easiest.
 
Common and correct to print it on a stringer. I used vinyl letters on a stringer then put clear resin over top.
 
Go to any hardware center and purchase the vinyl letters/numbers. Affix them to a stringer or a hull section (the inside of the transom in the ER is a good place). Then just lay a layer of impregnated fiberglass cloth over them. Done.
 
quote:

Originally posted by MikeeH

Go to any hardware center and purchase the vinyl letters/numbers. Affix them to a stringer or a hull section (the inside of the transom in the ER is a good place). Then just lay a layer of impregnated fiberglass cloth over them. Done.






Thanks everyone for the replies. I like the vinyl letters and clear resin method.
 
Back
Top