I have been having a problem with the engine room blower. Yesterday I crawled into the cramped spaces to determine just where the blower motor was located.
In doing so I saw that the inlet and outlet were 4" collapsible vent pipe like what would be used in a dryer. The blower motor was in the middle (actually near one end) of this piping. Not that it matters for this discussion, but the blower is a cheap looking DelMar.
What I did not understand was that the piping for inlet war run to near the forward end of the port ending and the outlet was near the forward end of the starboard engine. The blower is mounted so that it sucks and blows out the starboard side.
It seems to me that this configuration does not do much to provide air circulation/venting for the aft part of the engine compartment. This aft part is where the generator is mounted.
I think that the inlet pipe should be at the very back of the engine compartment on the port side.
Does this concept make sense to anyone else?
G
In doing so I saw that the inlet and outlet were 4" collapsible vent pipe like what would be used in a dryer. The blower motor was in the middle (actually near one end) of this piping. Not that it matters for this discussion, but the blower is a cheap looking DelMar.
What I did not understand was that the piping for inlet war run to near the forward end of the port ending and the outlet was near the forward end of the starboard engine. The blower is mounted so that it sucks and blows out the starboard side.
It seems to me that this configuration does not do much to provide air circulation/venting for the aft part of the engine compartment. This aft part is where the generator is mounted.
I think that the inlet pipe should be at the very back of the engine compartment on the port side.
Does this concept make sense to anyone else?
G