- Joined
- Jan 1, 2000
- RO Number
- 958
- Messages
- 484
Jeff first zip all your canvas on.
start in the front get a helper and make sure the front window is centered. put a snap in the center pulling the window down snug. a press in snap will seklf pierce the snap in the canvas http://www.outdoortextiles.com/browse.php?CatID=18&SubCatID=190&page=1 if your tool wont self peirce get a hole punch http://www.sailrite.com/100050?sc=2&category=7325
then pull your outer corners to the side and snap your corners. then fill in the rest of the snaps in the panel. quick fit pins are a easy way to pin it all in place then fill the pin holes with your snaps
http://www.sailrite.com/112723
any way work your corners when snaping dont start snaping your way along the whole piece.
put one in the front then the rear on a side window and fill it n after. bfore youy go to far check the rear center and corners. like the front window. without the pins just mark the center of the stud in the boat and put the snap in. you mentioned bigger hole snaps ar etheese turn buttons? the grommet oval in thre canvas and twist locks on the boat?http://www.sailrite.com/101059 if so there is a tool to cut the hole and 4 prong holes for the gromett but for 4 grommets it would be expensive.http://www.sailrite.com/common-sense-deluxe-hand-punch?sc=2&category=7325 without one its harder but if you can push the 4 prongs through the canvas put the backer washer on and just bend them over.if you cant push them through try making the 4 holes with a pointy tool like a ice pick ect. for the hole take a hot soldering iron and melt out the hole after.
start in the front get a helper and make sure the front window is centered. put a snap in the center pulling the window down snug. a press in snap will seklf pierce the snap in the canvas http://www.outdoortextiles.com/browse.php?CatID=18&SubCatID=190&page=1 if your tool wont self peirce get a hole punch http://www.sailrite.com/100050?sc=2&category=7325
then pull your outer corners to the side and snap your corners. then fill in the rest of the snaps in the panel. quick fit pins are a easy way to pin it all in place then fill the pin holes with your snaps
http://www.sailrite.com/112723
any way work your corners when snaping dont start snaping your way along the whole piece.
put one in the front then the rear on a side window and fill it n after. bfore youy go to far check the rear center and corners. like the front window. without the pins just mark the center of the stud in the boat and put the snap in. you mentioned bigger hole snaps ar etheese turn buttons? the grommet oval in thre canvas and twist locks on the boat?http://www.sailrite.com/101059 if so there is a tool to cut the hole and 4 prong holes for the gromett but for 4 grommets it would be expensive.http://www.sailrite.com/common-sense-deluxe-hand-punch?sc=2&category=7325 without one its harder but if you can push the 4 prongs through the canvas put the backer washer on and just bend them over.if you cant push them through try making the 4 holes with a pointy tool like a ice pick ect. for the hole take a hot soldering iron and melt out the hole after.