Flushmount Raymarine 48

archaegeo

Member
Joined
Mar 24, 2008
RO Number
29671
Messages
21
Our Regal 2120 didnt come with a VHF. The optional unit that regal installs is a Raymarine 48. These seem fairly cheap to buy aftermarket but I noticed they come mountable, but you can buy a flushmount plate for them.

If I wanted to flushmount it for cleanliness sake, how tough is this? Im a 20 year navy electrician, so not worried with the wirework, but Ive never worked on a fiberglass hull before.
 
Use masking tape, mark the tape for a cutting diagram, drill a hole large enough to fit the blade of the jig saw, use a hacksaw blade or fiberglass blade if you have one, slide into the line you marked & viola...Perfect!
 
Depending on how tight your dash is, it may be difficult to maneuver a jigsaw to cut a hole in the dash. We use a a rotozip. This is like a router but smaller, the blade is about the size of a 1/8 inch drill bit. I would also buy a flush mount kit. It makes it easier to cut the hole because the mount kit will hide the edge of the hole.
 
I have also been using the Rotozip more recently, but do some practice first. Also if space is really tight, there is a nice flexiable shaft for the RotoZip. For straight cuts where I can put tape down (and I prefer duct tape)--I prefer the sharp blade of a sabersaw.
 
agree with the rotozip. Just be sure you're not cutting into any wires behind the dash. The flush mount kit will most likely include a template for the cut.
 
PS. For safety wear goggles & a face mask. Don't inhale Fiberglass it's very nasty stuff!
 
Back
Top