Gear Oil

jwern

Member
Joined
Mar 25, 2008
RO Number
29700
Messages
2
I am sure this has been asked already. I am a new boat owner and couldn't find it on this site. I changed my outdrive gear oil. when i was checking my engine fluid levels I noticed that the Reservoir for the gear oil is empty. is this normal. if not what do i fill it with. there is no oil in the bilge area. I have a 1994 crownline with a mercruiser 5.7 liter with a bravo 2 outdrive.
 
You fill the reservoir with the same high performance gear lube you put in the drive. There should be a fill line on the reservoir tank.
 
It is normal to lose some oil, but a whole reservoir seems abnormal. You may have a yoke seal leak that is filling your bellows and eventually the oil will come into the bilge. No big deal. I would ask your mechanic to check your drive when you haul it for the winter.

Another question to ask is why the alarm didn't go off? Most reservoirs have an alarm on them to warn you when they are empty. This prevents you from running drive without oil.
 
Your drive should be pressure and vacuum tested every year to make sure the seals are not leaking. The pressure test makes sure oil isn't leaking out and the vacuum test makes sure water isn't leaking in.
 
You should have filled the gear oil from the drive up - that is the oil from the drive will eventually fill up the reservoir - a loss of all the oil from the reservoir could mean that you didn't fill it up all the way to begin with - or there is a loss somewhere along the way - could even mean that the oil leaked from the drive. Best to have this checked out before you chance burning up the gears in the o/d.
 
Your reservoir SHOULD have been empty since you drained all the fluid from the outdrive. The purpose of the reservoir is to keep the outdrive full of oil, when you drained it the oil in the reservoir was pulled into the outdrive.

Assuming that you properly refilled the outdrive from the bottom, how did you know when it was full? With a reservoir installed you should not do this with the upper fill plug removed. Instead you should have the upper fill plug installed and continue to pump in fluid until it starts to appear at the reservoir. Then you can fill the reservoir the rest of the way from the top.

Mike
 
hey guys thanks for the info. I did take the upper fill plug out and watched it come out of there. i will add more lube with the upper plug in. I just had the outdrive pulled and checked in the spring and the mechanic said everything was in good shape. there were no problems or worn parts. I only put about 30 hrs on the engine. The resevoire was full when i did the oil change a couple of days before i had it pulled. all i did was drive from my slip to the gas docks and back to have it pulled. so i will try to fill with upper plug in... thanks and will let you know.
 
Back
Top