Gen problem or Cruisair problem?

Mule

Member
exMember
Joined
Mar 3, 2002
RO Number
7719
Messages
74
My genearator surges but it only seems to occur when the AC / heat pump compressor is working.
Any thought as to the cause?
I have a 5kw Kohler generator and the AC unit is a Cruisair unit (don't know the model number). I ran it for about six hours Saturday night and Sunday morning. I t never got worse but it never got better either!
I checked for loose connections, etc on the compressor but found nothing.
Never has done this and the compressor seems to run fine on shore power (no surging).
Any thoughts?
 
My guess is you need to change spark plugs on the gen set
 
Ditto, change the plugs before doing anything else. I was a doubter how plugs could go afoul so easily in a four stroker, but I'm a believer now.

I now keep two extra sets on board.
 
judging by forum posts, these small kohlers seem to be plug eaters.... change the plugs first.
 
The 5E is a real rinky dink gen set, it has some big problems: cooling, sparkplugs,...

Cor
 
By all means check the plugs but A/C units draw big power, especially the initial start-up and depending on what else you are running at the time could just be a load issue. I have a 6.5KW genny and if the air and a bunch of other items are on and I'm near near max load the genny has a tendency to surge a little. That is even after new plugs, wires, impeller and coolant change. It's all about the load!!
 
I had a 4KW Kohler on my old 31 Silverton. That genset easily ran a 16,000 btu Cruiseair unit , hot water heater and refrigerator. I didn't think it would but it did just fine. In your first post, it sounds like the genset is surging, but in your next post, it sounds like you're saying the AC unit is surging? Start with plugs and see what you get. When were they changed last?
Greg
 
i had a 6.5 westerbeke on the maxum 37... would easily run both AC units at the same time plus the water heater, the stove and microwave... all on 300 hours old plugs ! cant' imagine a 5kw genses choking on a single AC unit even if other things are running.
 
My Honda 2Kiu (Pascal's FAVE unit) runs my 10K AC and some other stuff with no effort. I'm thinking plugs.
 
When you say surges, do you mean labors to stay running or are the RPMs going up and down under load?
 
Actually, I changed the plugs in April and this is the first time I've used it since the change!
When I say surging, I mean that the rpm's change rapidly back and forth, many times a minute. It runs fine under all other loads and under no load at all too.
I could recheck the gap on the plugs but they have less than 10 hrs run time on them!
 
Back
Top