gortex packing

wsgiarratana

Member
Joined
Aug 6, 2007
RO Number
28010
Messages
4
Sorry guys seen some old posts on Gortex packing but it's gettin me nuts.I run the boat let the shafts drip and next day snug'em up at the dock till little or no drip.Run it and it seems as though the gortex expands and I wind up with temps 95-102 deg.in 79-80 deg water and little or no drip at all while running at 3k rpms.Don't wanna damage shafts are those temps ok? can't seem to get right combo between expansion drip or no drip.Any input would be great,trying not to score shafts.
Bill G.
 
I am intersted in this also, as I am having the same problem. New packing gland also.
 
100 degrees is not hot, stuffing boxes are always warm because of the friction. i don't think you're goign to score the shafts if they're running around 100 deg.
 
I've run goretex packing for about 4 years now. When it is set correctly it does not drip to minimally drip while running and does not drip when at dock. There will be a slight temperature rise since there is some friction between the gore tex material and the shaft--this is normal and to be expected. Your slight temperature rise is not significant.

In my vessel I only experience a drip when I launch in the spring. The drip stops after a few hoiurs in the water and then I experience no dripping. My temperature rise is about 15-20 degrees above water temp. There is no damage/wear to my shafts (1.5 inch turning at about 2150 rpm at cruise.

Adjusting is simple--at dock after insuring the glands are thoroughly damp just tighten until drips stop.
 
I asked this question some years ago and was told that if I can keep my hand on the stuffing box at cruise,, then they are not too hot. 102 degrees is not hot at all.
 
100 degrees is just 1.4 degrees warmer than normal body temperature. Score a shaft? No way.
 
I have run this packing for 7 years now. It drips when I put it in the water in the spring, but then it stops. Would not use anything else. Sure beats the cost of installing dripless.
 
Thanks gentlemen for the timely responses...I can rest assured now that I am not damaging my shaft.
 
No, I have not but intend to do so the next time on the boat.
 
SaltyCam....when you do shoot me e-mail or post it would be interested to see what it reads.Thanks,Bill
 
Back
Top