Hull Cleaner

quote:

Originally posted by C_Spray

Another thumbs up for Starbrite Hull Cleaner. Best stuff I've ever used; far better than On/Off for Chesapeake Bay stains...






Starbrite works for me too.
 
quote:

Originally posted by Padraig
So is it the air type lifts or lifts in general???? I have ny 28 foot on a convential type freestanding list on a fresh water lake. It keeps the bottom clean and I sleep well at night when the wind and waves come up as I don't worry about banging against a dock or breaking a mooring. Our lake (Western NY) does freeze but being free standing the list comes out and is stored on land.Thanks,




Padraig
I agree with you and ITK- I can see value in a proper boat lift, but the Air bag type not being proper for many reasons ITK stated, especially where there are major temp shifts.
The temp here in southern NY can shift 20-40 degrees within a day or two. I have seen my Zodiac go from fully inflated to a limp blob over such a time, not all the chambers deflated the same amount and can imagine what would happen to a boat sitting on airbags going through this type of temp cycle.
 
Over-inflation IS a big No-No. I only inflate enough to get the outdrive, in the trailer position, about an inch out of the water. The waters where I keep my boat 12 mo/yr goes from 75* to 40*, gradually. I have never had a problem caused by that water temperature gradient in 7 yrs. However if the forecast is for several nights below freezing, I do deflate so that the boat sits in the warmer-then-the-air water so I don't have to winterize my boat. This only happens once or twice a winter.

I think most concerns about Air Docks are not really valid. I'll have to find/read that article in Boat US. I'm curious what they say and why. I think after 7 continuous years of use, I've dealt with any issues with them.
 
quote:

Originally posted by C_Spray

Another thumbs up for Starbrite Hull Cleaner. Best stuff I've ever used...






Oxalic Acid Solution with the same solvent that is in White Board Cleaner.

http://www.starbrite.com/msdssheets/81732-msds-7-25-06.pdf

Do we see a pattern? Just buy granular Oxalic Acid (WM has it) Get a 5 gallon bucket and fill it with 1/4 inch of water. Pour in a few ounces of Ocalic Acid. Put a rubber glove on your hand.

Dip this "scrubby brush" into the solution ****MAKE SURE IT IS NOT A 3M SCRUBBY OR ANYTHING THAT WILL SCRATCH THE GEL COAT****

scrub%20brush.jpg


Lightly scrub stains. Wait a few minutes. Rinse
 
Just wanted to follow up to say I had a chance to us the Slimy Grimy on my haul today and it worked GREAT! No elbow grease needed :-) I mixed the container with 3 gals of hot water and used a soft brush on a stick, all the scum came right off. Regular boat soap would even touch it, I though the haul was stained until today :-)
 
Next time mix the slimey Grimey (with hot water) and apply it with a pump up garden sprayer, it usually cleans without scrubbing.
 
I mix it with hot water and it literally melted off as soon as the brush touched it :-)
 
Great product but try the sprayer next time, easier faster and gets in places that is hard to reach.
 
First, I powerwash the bottom paint and water line. Then I use toilet bowl cleaner on the fiberglass and on the drives. Use a pump up sprayer with the toilet bowl cleaner in it (not diluted), spray it on, lightly scrub, let sit. Then use the power washer to rinse.
 
Back
Top