Kicker...how big?

Cyprox

Member
exMember
Joined
Jan 1, 2000
RO Number
1834
Messages
14
With the price of gasoline the way it is I recently got rid of my old Trophy with twin Optimax 225's. The bot and engines were a pleasure to use offshore, always knowing that the second engine would provide steerage and propulsion in case one engine quit (albeit at hull speed...7-8 mph.

I got a smaller Trophy with a single 225. The weight difference and the single engine would solve the gas economy question. However going offshore with a single engine is not smart.

This brings the subject of kickers. Although my 225 could not push the old boat faster than hull speed, it did have torque.

Will a 9.8 HP kicker be effective? Will a 15 HP be better?

Thanks.
 
The 9.9 and 15 are basically the same engines. The 9.9 is often a down rated 15, because of the limit of no more than 10 hp on certain lakes. 15 hp or 9,9 hp either should push your boat at a displacement speed, but it may be slower than 8 knots. 8 knots would assume a waterline lenght of 36 feet--and I doubt that your Trophy has a length waterline of more than 22 feet, so max displacement speed will be in the range of 5.5 to 6 knots. The 15 will get you home fine--and that is what I use in a 25 footer I take on long trips. (Like to Alaska).
 
I'm with Bob on the 15hp. My old 15 Evinrude pushes my 24' cabin cruiser 5-6 mph at WOT.

Get a long shaft(following seas tend to pull a short shaft out of the water)and a good quality retractable kicker bracket if the boat doesn't already have an integral mount.

Kev
 
you might want a lower than standard pitch prop
 
Many of the motor manufacturers make a "sailboat motor"; already set up for pushing heavy loads at lower speeds. You might want to look into one.
 
Look for "High Thrust"-type kicker outboards by the majors. Larger, lower pitched prop and different gearing for just this purpose. Just remember if you have to fight wind , seas and current you are likely better off setting your anchor and radioing for a tow. I had a longshaft 15 hp kicker for backup on a 23' Sea Craft that I used years ago for offshore "work" and know at least 1/2(or a lot more of) the time I was out there the kicker would not have helped at all if I had tried to use it. The few times I did try it to check it's effectiveness , it was a serious PIA to steer the boat as the raisable bracket had to be mounted so far off the centerline and if the main single O/B was used to steer it presented major drag. You will likely need a separate supply of kicker fuel onboard as I'd expect that would have to be 50:1 mix as opposed to the automix of your main O/B. I finally took mine off as the many drawbacks seemed to outweigh likely potential benefits, but some feel differently about that.
 
The boat I'll be getting is a 25" Trophy. What I need is some steerage and forward motion at around 5 feet. Her in Georgia the seas are usually 2-3 feet. If I get caught in bigger seas, I agree the kicker may not have enough thrust, at which point I may just have to throw anchor and call for SeaTow.

Although not really a replacement for a 225HP engine, it is nice to know that there are other options in the bag.

The engine I got is a four stroke, so most likely th ekicker will be the same, so the gas if not used can be recycled back into the main tank.
 
Back
Top