LED flare

Looks nice... especially if they don't expire for ten years.
But really... how often are marine flares set off? I've been boating for 20 years and never known one to be set off in our area... except people shooting off the expired ones instead of fireworks.
 
True. But these look like a very good addition to a safety kit.
And flares burn out fairly quickly. Where these "burn" for up to 100 hours so they say.
 
Interesting, but not very useful on my boat. Here's why:

Not USCG/SOLAS approved.

I suspect that the brightness of one handheld red flare is many times brighter than several of these ( My guess is based on the amount of energy stored in a perchlorate flare, vs a battery )

I suspect that the monochromatic LEDs do not show up very well on FLIR and/or other night vision equipment. I could be wrong on this one.

A person seeing a red LED will not usually associate it with "distress". A person seeing a handheld red flare -will- notice it, and investigate.

As far as contamination: Properly disposed of, flares should be a minor issue. Same is true of batteries. Both can be contaminants of not properly handled.

The first two, by themselves, make this a "neat/cute" item rather than safety equipment, at least, on my boat.

--

I really like LEDs. But not in this application.
 
But they will blink in an SOS pattern.

I'm not saying they will replace standard flares.

First get some ones attention with a standard flare. Then fire one of these up to lead them in and/or hold their attention. Like I said, they seem like they might be a good addition to standard flares. They also work when wet and can't burn a hole in your life raft. And if they help save/find your butt who cares about USCG/SOLAS approval. :-)
 
They make a special one with red and amber LED's for the Coast Guard auxiliary as a public safetly light. I bought one. There is no way you can use it as a night time Visual distress signal.

I know fire and police departments that use them for all the reasons mentioned on their site, safety, reusability. I think they make a good alternative to road flares.
 
"There is no way you can use it as a night time Visual distress signal."

Not bright enough I take it?
 
Michael, do you feel it's an adequate PSL? I have the rotator with a red and a yellow sealed beam and it's not all that impressive. While putting quite a load on the electrical system... I keep looking for ways to make more noise and have more light!
 
These LEDS are fun gadgets, nice to have in a safety bag and I feel they can be of some use on a river or the ICW or very near to shore situations.

I use them mainly for decoration, hope always springing eternal that when you put these on the side of the boat in the rotator pattern, that the latest crew of GGW will show up for an after shoot party.

Unsuccessful to date....but then, let me tell you about blue lights.
 
Capt Bill, They don't glow the same way a pyrotechnic flare does. They are regular LED's that flash in various patterns, you can see how they look on their web site. They are ideal for laying out in a line on a road but no one on the water would recognize it as a distress signal. It just looks like any other blinking red light. The glow of a regular flare is unmistakable and distinct.

J-D, I have the traditionalrotator as well that I never found a good way to mount. You're right, they draw around 7 amps and are not bright. They are barely visible during the day. This one is not much better but it would be easy to mount and there is no wiring required. And they are only $50. I haven't figured out a good place to mount this one either. The problem is, if I mount it on my arch, you will only see if from a distance since the arch would block most of the light. I think the best kind of lights are the xenon strobes like Sea Tow uses.
 
Thanks, Michael - We're a much smaller boat. I replaced an angled rod holder with a welded vertical one. Had to eliminate the gasket and add a backing plate before it didn't work under the strain of the light above. Then 1-1/2" PVC pipe adapted to a PVC toilet flange. SCH 40 wasn't stiff enough, there's a SCH 80 available. I trimmed a piece of dock board to a tight internal fit and it's stiff enough now. Beam wasn't level to the water surface so I went out with an angle finder then came back and hot bent the PVC to set the rotator level at our running angle. Phew! I tried to email you, but your part of 1SR is down on the web right now. You can reach me at closest unit to 32250 and contact PE. Would love to chat. There's another source for lights I can mention that way.
 
Might be good as a "locator" and in ADDITION to regular flares. By themselves, not for me.
 
I used on for a public safety light, but got rid of it. It was too directional and not very visible in daylight. It wasn't too bad at night. The rotating red and amber can be seen at a much greater distance.

5SR 15-07
 
quote:

Originally posted by MichaelNJ

Robbins, how did you mount yours?






I presume you meant the Powerflare. I constructed a PVC mount that tied to my hardtop handrails.

My red & amber is permanently mounted on top of patrol signs which sit in middle of my hardtop.
 
Michael,

If your PSL can't be permanent, can you make a base that cradles your arch and clamp it together around the arch or tie it down with bungee cords?
 
I'm looking for something simple and quick. I thought of using 3M Dual Lock. It's like velcro but it won't come apart. I was thinking of putting it on top of my Radome. That's the highest point on my boat and visible from 360 degrees. The problem is that you would only see it from a distance of 50' or more. A piece of PVC pipe with a flange on top may be the best bet.
 
PVC flange fastened to arch (or clamped around it) plus short piece PVC to get above radome... If you sanded the pipe and the fittings, you could make it loose enough to slip in and lock with a clevis pin. We have a member with PSL mounted on top of radome, but I think it's permanent or semi-permanent. Can check if you like.
 
I have until the spring to figure something out. Shouldn't be too difficult. Always interested to see what other have done.
 
Back
Top