Wiring in two seperate mountings for the light staff is fine. However, among some of the other issues/advise mentioned above, you will need to be concerned about the mount itself. When you have the light staff installed in one of the mounts and energized, the unused mount will also be energized. It's only 12volts, so there really isn't much of a safety hazard, but if kids are onboard, they may stick their fingers in the 'empty' mount and get a little shock. The mounts may have a small drain hole in the base, but they are prone to clogging. Spray could then get into the empty side and short the + to the -. At the very least, you will want to have a secure, water tight cap for both mounts (should come with the new mount) or better yet, wire in an 'a/b' switch so that only one side is energized at the time.