Nav Lights

rich356

Member
exMember
Joined
Apr 3, 2007
RO Number
25751
Messages
249
Just to see if they were all functional, I turned on my nav lights this weekend and I noticed that my all-around light is burned out. I'm going to get a new bulb of course, but myself a few other people were talking about the legal requirements. From what I read, in a boat the length of mine (41.2 feet LOA), I said that I thought it was 100% required by law. Another person thought that since my stern light, red and green side lights and the white light I have on the front of the flybridge worked it was OK to go out at night without the all-around light working. I really don't think that's true, but the white light that I have right at the front of the flybridge is something that a lot of boats my size don't seem to have so I don't know if that makes a difference. I wouldn't think it would because you can't see it from behind like you would with an all-around light.
 
under 40 you can substitute an all around white light for the forward 225 and the stern white light.
above 40, you must have them, although some all around lights are actually 2 lights / bulbs. one forawrd 225 which comes on with the nav lights and second bulb facing aft to make an all around anchor light.

as long as you dont' anchor out outside an designated anchorage, you can navigate at night as long as your nav lights are working even if your anchor light is out.

get spare bulbs while you're at it...
 
My boat came new wired so that just the forward facing half of the high all-around light was lit with the nav lights. Apparently that and the stern light must combine to meet the requirement. However, I put a dinghy on the back that blocks the stern light. I rewired so that the both the forward and aft lights of the high all-around would be lit with nav lights.
 
PJS That will work ok, but one purpose of the stern light is to show other boats where your stern is and how long your boat is. This can be important for nighttime navigation. Different types and sizes of boats have different configurations so that you know the type of vessel you are seeing in the water.

This really saved my cookies one night. I saw a boat with a configuration I'd not seen before. I strained my memory, finally remembered that was the configuration for a tug pulling a barge. From my perspective, I could see no lights on the barge and had no clue until I got closer. I almost cut across between the tugboat and barge!!!!

If you are boating where there is commercial traffic, it is a good idea to refresh your memory of these configuration each season.
 
Rich356, you are discussing two separate sets of lights. For a vessel your size the all around light is your anchor light - it has nothing to do with navigation underway. As Pascal says if you are anchored outside a designated anchorage at night you need to show a single all around white light. If you are underway you need port and starboard running lights, a forward facing steaming light visible through a 225 degree arc and a stern light visible through 135 degrees.

PJS, just to clarify what Flutterby wrote: you are OK as long as your boat is less than 39.6 feet. Beyond that you need two separate lights, one forward facing 225 degree and one aft facing 135 degrees.
 
For those, like PJS and me, that have a dink vertically installed on davits on the swim platform as well as a stern light (now not visible due to to dink) what alternatives are there to be legal? I've thought of rewiring my anchor/nav light to be an all around when underway, but are there better solutions?
 
Sea Gull is right.
Your anchor light is burned out. The way my boat is wired you can't turn on the anchor light and the running lights at the same time, the switch is nav/anchor and off.
 
the stern light isnt' going to tell you much about a boat unless you're coming from behind. if you're going to cross from the side, you're not going to the see the stern light.

Len, you can do that (use your all around) but only if under 40'. otherwise, you need to rig the light higher than the dink or maybe relocate it to the side, I dont' think it has to be in the center of the transom
 
quote:

Originally posted by Flutterby

PJS That will work ok, but one purpose of the stern light is to show other boats where your stern is and how long your boat is.






Huh?? Does the stern light blink morse code to tell you the length?
 
Yeah, I don't think I recall seeing a stern light at the last barge being towed or a nav light in front of barges being pushed. Instead, the three white lights is enough to say...stay away, this is a wide load coming.
 
I installed a new stern light on the rear of the superstructure roof; high enough that the dinghy doesn't block it. As far as I know there's no requirement regarding how high it is. On my fishing boat the all-round light is mounted on the bimini. They both work quite well.

The barges are SUPPOSED to be lit; but the lights are often battery powered and there's no guarantee they'll work. If the barge is on a towline there may not be anyone to fix it, either.
 
Ah, that makes sense. I thought that's what it was (especially since when I toggled the switch over to anchor nothing came on), but then I saw another boat going out with the all-around lit. He probably didn't have the forward facing light though. Of course, when I climbed up to take the bulb out I dropped it off of the hardtop into the water so I'm not exactly sure what size the bulb is. I took the bulb out of the forward facing light as I'm assuming it would be the same bulb.
 
I hadn't considered that someone might construe my revised nav lighting as an indication that my boat is shorter than it really is and thereby cause a safety hazard. My boat is just under 40' so I am probably borderline legal/illegal according to the posts above. In my case the all-around light is mounted almost straight up from the transom (off the back of a rear leaning radar arch) so it does give a good indication of where the end of the boat is too. From a practical standpoint it seems to work fine and provides the safety of a readily visible light off the stern. From a distance at night I'm not sure that anyone could tell if it is the back of a all-around light or a more specialized stern light. It's just a white light in the distance. Once close enough to tell it is the high mounted all-around light they would also see the glow around the dinghy from the stern light. I feel safe with it.
 
If you can see the stern light on a boat, then you can't see any of the other lights (sidelights or masthead). So I don't really see how it tells you anything about the length of the boat.

Seeing more than one white light though is enough to make me keep my distance...
 
Actually after reviewing some of the posts above, I might be legal in any case. My all-around light is comprised of two lights. One 225 degree forward light (since it always came on with the nav lights I assume it has the correct spread) and a separate aft light that I hotwired to come on with the nav lights (I can only assume 135 degrees since that completes the circle when used as an anchor light). And the aft light, although higher than my OEM installed stern light, is indeed at the stern. I may have lucked out on this one!
 
Joe

As you are passing a boat going in the opposite direction. When you can see the stern light, you know you have completed your pass. Sometimes it is totally dark out there and another boat has no other lights onboard turned on. That is the point: if "you can see the stern light on a boat, then you can't see any of the other lights", giving you a reference.......
 
I don't see the point of that. A white light is visible 360 degrees, so it doesn't tell you anything without the sidelights. The disappearance of a sidelight is what tells you the pass is completed.
 
I'm referring to a stern light which is normally installed on the transom below the gunnel; the type which can be blocked by a dinghy. Some stern lights are on a pole and would probably show from most angles. But you can see a stern light after you pass the vessel if you look back.
 
Back
Top