Outdrive Gasket

ALKA2710

Member
Joined
Mar 5, 2007
RO Number
25407
Messages
670
Put my Alpha drives on the other day and after everything was tightened up I noticed a water o ring in the dirt. Now I put grease on the ring to hold it in place and am 99% sure it is the old ring but to be sure I am going to pull the drive. Do i need a new gasket. I am just being lazy and am tired of the boat store. The motor has not been run yet.
Al
 
Hey, it's a little, itsy-bitsy o-ring, right? What's the harm, how bad could it be if it failed? Of course, I would probably replace it, but that's just me...
 
I'll give you the correct advice and you can do what you want:

Anytime you pull the drive the gasket set should be replaced. Why? Because if you properly torqued the nuts, you have compressed the O-rings. They are there for a reason...use them all.
 
Wasn't trying to be a smarta**, sorry if I came across that way. When it come to repairs that keep water out of the boat, I would never, never, never (to use your words) "be lazy"
As Mr. Sibley does moderate the engine / electical / plumbing forum, so I would defintely value his advice!!!
 
Sorry this was a stupid question. I guess i new that they had to be replaced. Thanks for the replys
Al
 
I have removed and reused the flat gasket may times -- if it comes off in one piece -- I use a slight bit of silicon on the side that came away and reassemble -- WITH THE O RING THIS TIME----
If the gasket breaks by sticking partly to one side and part to another -- I replace -- that is with a mercruiser of course ---

Volvo does not have a gasket to start with if I remember right --
 
The potential amount of damage that can be done by not replacing old gaskets is like playing russian roulette.
 
Al,
How can it be a stupid question if you're not sure of the correct answer?
 
Back
Top