Prop noise?

robedney

Member
exMember
Joined
Oct 19, 2004
RO Number
15560
Messages
310
So, on the 58' project boat (single screw) forward works great -- no prop vibration and that big fat shaft runs nice and true (although there are transmission problems at the moment, but that's another story). So, here's the thing: Shift into reverse and after a bit there's a nasty clanking. At first I thought we'd backed into something. Not so, happens anywhere. So, check me out on this, here's my theory: In forward the prop is "pushing the boat" and therefore snug up on it's taper. In reverse it's "pulling" the boat and therefore has a chance to slide back (assuming a loose nut) and start wagging on the shaft and perhaps hammering the key. Part of my reasoning for this has to to with the fact that the noise is delayed if I shift from forward to reverse, and only starts after a bit of time in reverse. Needless to say I've stopped shifting into reverse until I get wet and have a look -- but I'm trying to prepare for what to expect down there...

Thoughts?

Robert
 
Engine / trans mounts OK ?

Just a thought on something easy enough to check.

Willy
 
Engine / trans mounts OK ?

Yup. In fact if you sit in the engine room right at the engine/trans you can hear the noise coming from aft.
 
From your description I would look at the more common issues. But you may have already bin there.

Strut bolts?
Cutlass bearing?
rope around the prop?
Key is gone or broken?
etc.

I would expect a lose prop to shift and knock only when you change from foward to reverse and back. Once its set it should settle against the nut or shaft.

Screw driver to the ear off a strut bolt inside see if you can get a better read on the source? Dont know ?

So I have no idea but want to know what you find. Cause it makes me go HMMMMMMM.

Willy
 
One more thought

Has it a zinc on the shaft that might have come loose?

Willy
 
Hopefully you haven't lost the 2nd prop nut. Along with prop tightness check to see if your prop shaft zinc is loose and sliding or if you've picked up jetsom. While you're under, make sure all zincs are tight & not begging for replacement. Might you have Spurs cutters that need new "bearings"? Anything on the transom that could have loose hardware,... ladder, steps, swim platform?
 
good thinking. backing off and hitting the rudder??
 
That's what it sounds like to me, too. Might have LOST a prop nut. Definitely check it out before it gets expensive.

You said you had transmission problems; is the shaft sliding back when you go astern?
 
Maybe just cavitation. Does the noise continue with both engines astern at idle? My boat hammers a bunch when I push hard astern while still going forward.
 
Back
Top