Propane Stove Question

manticore999

Member
Member
Joined
Apr 22, 2005
RO Number
17103
Messages
408
We recently bought a 1980 Carver 3396 - some of you have already helped me out a lot - and now i have a stove question. We have a Princess propane stove with 3 burners and an oven. In order to light the oven you have to hold in the red 'pilot' light, light the pilot, and then turn the knob until the oven kicks on. The problem is, after a few minutes the thing just shuts off. The previous owner kept lots of the original manuals but not this one, unfortunately. I'm suspecting a bad thermo-coupler but I'm and IT guy by profession - i don't know anything about stoves.

Any ideas?

Thanks, all.
 
If the air is out of the line, then the thermo-coupler is the guilty party. Make sure the pilot light/flame at the thermo-coupler is a strong one. I have seen where the TC was good, but it was not getting enough flame to operate.

Ken
 
Try adjusting the tin that redirects the pilot flame to thermocouple it may be not heating thermocouple to a temperature hot enought to keep gas on and pilot lit. And as Ken said i would check the propane solenoid on off switch , the one hooked to your sniffer mine went last year the build up of some kind of oil in propane over many years will gum up that solenoid and it would not open fully, Sure made a diffrence in top burner out put also, Better get a gas man involved for anymore trouble shooting. Lifes to short as it is.
 
Back
Top