Reusing Shrink Wrap

GrecRI

Member
Member
Joined
Apr 21, 2006
RO Number
20962
Messages
248
The shrink wrap is coming off this weekend, and I can't help but wonder whether I would be able to reuse it next year if I was careful about how I removed it. It just seems like a shame to throw it away and caugh up another $400 in the fall to do it again.

Does anyone do this?
 
There is a fellow here that has re-used it at least 4 years. I have seen one other re use it but much to his personal injury he put it back on inside out the year he re used it. The trick is to cut the hem lines carefully so you can re attach new sections as required to draw it tight again.
Good luck!
 
No matter what you do it will still be loose - this is how boats get damaged. It's not possible to draw the lines up tight enough to ge a good fit - 5-8 mil shrink wrap shrinks at least 50 percent by 50 percent as it cools, which is where the tension comes from that keeps it from flapping and damaging mounts, popping stanchions, rubbing and chafing paint and gelcoat, et cetera. Not to say it isn't possible, just not a great idea.
 
I have seen guys do it but a freind of mine tried it this past winter and it didn't make. NC is correct in that it is hard to get tight again.

Good luck
Niles
 
Yes you can do it. I get 3 seasons out of mine. Then I replace it as I stay in the water & don't want to risk the hem band chafing through in the middle of Feb. My frame is all labeled & I have used the samne frame for six years. I cut the belly bands off, pry the cover up at the corners of the transom & then feed it all forward. That allows me to pull the cover up over the bow. I think my boat is a little more difficult than yours would be. My hardtop is 16' above the waterline on a 33' flybridge. I use 6 or 7 belly bands. Tighten them as much as I can. Come back a week later & retighten.
So, YES it can be done.
Al
 
Yes you can do it,I too have seen it used for up to 3 years. Make sure you use the right tape. Stay away from the duct tape!
 
I just removed my shrink wrap yesterday. This was the third season of use. Looks like with just a couple of repairs I will get another. My boat is store just feet from Lake Superior, so receives a lot of wind and snow.
To get it as tight as I can, what I have done is run about 6 lines from on side of the boat to the other. I reinforced the shrink wrap with shrink wrap tape just above the cord that was ran around the hull. Put a small slit in the shrink wrap where I reinforced it, then I tie in a line and run it under the boat to the other side. I then snug it up as tight as I feel comfortable.
Also when I removed the shrink wrap for the first time, I took a picture of how the marina had created kind of a skeleton from webbing. That way I could try to do the same.
Al
 
Chafing in winter is a fact of life. We have wood rails and over the winter the shrink polishes it down to the wood here and there.
 
Back
Top