Rooster tail

GilBry210

Member
Joined
Dec 8, 2006
RO Number
24489
Messages
74
When underway I get a spray out the rear of my boat that shoots out like a rooster tail. This is enough of a problem that my tubers get sprayed in the face during their ride, very annoying. The only way I have found to sort of correct the problem is when I trim the lower unit out. However, I then start porpoising and have to trim back in. I have a Crownline 210 CCR with 14.5/19RH Rapture SS prop on a Volvo Penta Cobra SX outdrive. I have Instatrim trim tabs as well. I have thought about installing a Stingray hydrofoil, possibly the new XRIII, it claims to control the force cone and the illustration appears to be correcting what I think is wrong. Basically it creates a larger cavitation plate. Please offer your ideas, Thanks in advance.
 
You would think trimming it all the way in would solve the problem. I'm not sure a hydrofoil would help. They are just $50 and come with a guarrantee I think. So I would assume that you could return it if it did not perform as advertised.
 
I agree w/ CC that trimming inward should solve the tail issue. If you had stated "outboard", I would have said that your engine is possibly mounted too high. But w/ an I/O, it -should- be in the right place. That really only leaves one thing: you need to find the position between rooster tail and porpoising. There may be another cause, but I can't think of one...
 
I doubt that the foils will help. I drive a Catmaran with the outboards mounted on Armstrong bracket, and being mounted "opposite" rotation, causes a rooster tail. I added Permatrims, which are larger than the Dolfin's and most other foils, to allow planing at lower speeds. It did not decrease the rooster tail. Porpoising is caused by either a hook in the bottom of the hull, or bow trimmed up too far. Use the trim tabs to vary the attitude of the boat, and then trim the outdrive so that the thrust is parallel to the surface of the water. Ie. use the tabs to push the bow down to get rid of the porpoising.
 
I have a 19ft Wellcraft Excel, I didn't have a rooster tail, but I bought a Hydrofoil XRIII to get up on plane faster. It works great and you don't have to drill any holes. It mounts through the hole that holds the torque trim plate. Well worth the money, and if it doesn't cure your problem, you don't have any holes in your cavitation plate. $119 on ebay.
 
I would think that tucking your drive down would stop both a rooster tail and porpoising. Sounds like our outdrive is too high up, pushing the bow upward and directing the prop wash/thrust upward toward the surface. Sounds weird.
 
The longer tow line will help, but your problem it bad trim. Trim the drive like eneryone else has said, and move all the weight in the boat you can forward.
 
Agree with Jim,

Just need to find the right balance for the trim. I get a rooster tail (drive trimmed in)when I start and I trim up until it's gona...that's kjnd of like a guide for me...If I trim too far up I get the porpoising.
 
Back
Top