Hello Bob,
I love the picture - taken by a fellow member of Lakeside Yacht Club in Port Stanley, Ontario last summer. Too bad about the hard top. Talk to your sales rep and see what he has to say about any rumors he has heard about Sea Kings HD solution for the new KA band. My installer seems to think that the cheapest way to satisfy everyone is to offer a second dish - he claims they are working on it now - that is the only reason I brought up the second install. (for DirecTV) I like the idea of spreader wings, lights and mounts, they look great.
Ocean Marine Systems is the manufacturer of my dink cradle. It is a very simple unit - I have a soft floor dinghy and 8HP motor so it is lightweight - the unit tips forward and I just pull it up and on. For heavier dinghys they have a pulley system, two rings on the dinghy and two on the boat and it will pull it right up. The cradle is removable - the two parts that hold the assembly are two long u-shaped bars that overhang the platform. These are always there, only the cradle removes, so you still can "stub" your toe - but they are also large enough and so is the swim platform, that I have never done it. It is a little pricey but it is the smallest cradle that I found and I would recommend it to anyone. You do have to pull the throttles back slowly and watch that your wake does not catch up and lift the dinghy too much because our platforms are low. I have been in 6-7 foot following sea also and the water never touched the dinghy, it is up high enough.
My A/C unit is 18,000 BTU. Directly under the forward port passenger seat there is a large hollow area that is above the aft port stateroom and there is "just" enough room for the unit and tilt for the drain line - mine leaked into the stateroom once in rough seas because it was holding too much condensation, a little more tilt and a larger hole for the drain line fixed that. The airflow is split, one long vent in front of the seat and one smaller aft. It does a decent job of cooling and a great job at heat. Of course on a hot summer day it feels great just to sit in front of it. There is enough water pump to split into your existing cooling line - my installer checked with manufacturer and also there is enough amperage left on the #2 side of the panel for plenty of power. I run all three a lot, no hairdryers, vacuum or microwave with all three running, but that is normal anyway, I would not want to put that much stain on any power system or cord.
Just got over a foot of snow at my house here.... warmer days are coming and I can't wait.
Mike Brookins