Setting the Delta?

89SeaRay220

Member
exMember
Joined
Jun 21, 2006
RO Number
21903
Messages
151
I've had mixed success with setting a delta. I always use 7:1 scope (accounting for the tide and distance from the bow to the water). It usually sets okay, and then will drag an hour or more later with no change in wind. Do I need to power backward pretty hard to set this anchor? I never had to do that with my danforth. I switched to the Delta 'cause I installed a bow roller and windlass (which I love). The Delta self-lauches and looks alot nicer, in my opinion.

Btw, I have a 1989 22' (23'8") Searay Sundancer. I usually anchor in about 15' - 20' of water with a mud bottom. I have a 14# Delta, 10' chain and 200' 1/2" 8-brait line.

Thanks,
Dan
 
Tell us what the bottom is like.

Like Greg say, 20' of chain will do wonders.

Jonathan
 
yep.. more chain. what kind of mud ? soft, light mud ? I think that in light mud, a delta doesn' have enough power... it doesn'have the flat flukes of a danforth.

all my danforth have always self launched... i don't give a #%$rb2@gr5t^&rb2@gr5trb2@gr5t about how pretty an anchor is...i want it to hold my boat!
 
I've only used danforth with anywhere from 6'-12' of chain. I anchor mostly in mud and almost never pull out unless I'm in a weedy area which sometimes happens after very wet winters. I seldom use more that 2.5 times depth...it's always during fishing with good tidal movement. What good is a pretty anchor if it doesn't hold.
 
You should back down hard to set any anchor. I have never had my delta fail to set and hold that way. I can not say the same for a CQR and several Danforths.
 
The bottom is critical. Both the Delta and Danforth are excellent anchors, but the Danforth is better in soft sand and mud. The Delta is not perticularly a good mud anchor. If you are in 1 to 3" size rocks--good luck! with any anchor...

Yes, go slowly until the anchor sets, then back down. I always "power set" an anchor. It may be that in your area that a Danforth or Fortress is really a better anchor...
 
I would really rather not add more chain...I have my rode all marked, and i'd rather not have have to change that all. I don't know what kind of mud i'm archoring in, perhaps my buddies from the LICC could tell me what type of mud is on the south shore of LI, specifically, Zach's Bay.

What is the proper procedure for backing down on an anchor to set it. How much power, for how long?

I know the anchor is of sufficent weight for my boat, Lewmar actually recomends the 9# for my size boat, I have the 14#.
 
The Delta's get there holding power/strength from penetration into the sea bed. It is possible to have an anchor that is too big. Power setting is always good, which is what I do, but what if the wind shifts ?? The wind into the boat is the only resistance. If the anchor is too big it will not dig. I use the analogy of getting ice cream out of a container. Which is easier and digs deeper into the thick stuff, a big serving spoon or a small dinner spoon ??
 
if you add 20' of chain, i don't see how hard it is to remember that you've added 20' when looking at your markers... Chain is the best way to keep the shank near the bottom to get the anchor to dig.

Every anchor gets its holding power by digging in the bottom, not just the delta. wind shifts, if strong, can indeed cause the anchor to pull out. Plows should reset on their own whereas the disadvantage of a danforth is that it may need to be cleaned before it digs back in since it may have a large blob of mud or grass between the fluke. depends on the bottom.

this is once again where a lot of chain helps. in moderate wind, all chain will drag on the bottom and hold the boat before it even pulls the anchor sideway.

i don't think there is any such thing as too large an anchor. yes, you might need a little more power to set it in calm conditions... if the wind is light and you dont' use power it will rest on the bottom. if the wind picks up and pushes the boat it will start digging in.
 
When setting the anchor for an over stay I always check the weather for predicted wind direction/speed overnight, then choose a location and direction where I'll drop the hook and back down... it helps maximize the odds of a restful sleep :-)
 
Back
Top