Stern Cleats

bmetros

Member
Joined
Dec 15, 2006
RO Number
24569
Messages
34
I would like to add 2 stern cleats to my Maxum 2300 SCR. Currently, the cleats are positioned so that when the ropes are crossed (at the dock) they make it hard to access the boat from the rear. I figure if I add 2 cleats to the built in storage box (1 each side) this will still allow the ropes to cross and also allow easier access. How big/thick of of a backing plate should I use? and what material would you suggest? The cleats will be 8" or 10".
 
I had extra cleats installed on my boat too. Your backing plate needs to be about an inch longer and wider then the cleat's footprint. I used 1/4 inch SS [it was free], but aluminum or a strong plastic should work ok too. Drill through the backing plate and use SS bolts with SS washers and SS nuts. Be sure to seal the hole with a liberal use of sealant.
 
Scrap blocks of laminated fiberglass work well for backup plates, too. There might be some stuff around the boatyard.

Flutter, whoever drilled that 1/4 stainless for you must have been on a full charge...
 
My First Mate was a mechanical engineer and had access to the latest state-of-the-art materials and equipment. He took advantage of these when outfitting my boat. What a guy!!!
 
Back
Top