When heading out to go fishing yesterday I found that I could not get the engines over 3,000 rpm. This WAS NOT a full throttle setting. The 3,000 rpm (and about 19mph which is close to normal for this rpm) were achieved at about the same throttle position as normal. There was a lot of throttle control movement left, it just did not make any difference. This was not a slowly developing problem. The last time I ran the boat, a couple of weeks ago, everything ran fine.
I had a diver check and clean the bottom and all running gear. He said the shafts were pretty dirty, but that the props were not very bad. I did not have time for a run after the cleaning, but I am not expecting any difference based on the divers comments.
A separate problem is that I am having problems removing the raw water filters. It is time for an inspection/cleaning and I can not budge either. Must have overtightened the last time they were off. Anybody have any tricks?
G
I had a diver check and clean the bottom and all running gear. He said the shafts were pretty dirty, but that the props were not very bad. I did not have time for a run after the cleaning, but I am not expecting any difference based on the divers comments.
A separate problem is that I am having problems removing the raw water filters. It is time for an inspection/cleaning and I can not budge either. Must have overtightened the last time they were off. Anybody have any tricks?
G