Bonding System

RWS

Well-known member
Member
Joined
Feb 1, 2007
RO Number
25075
Messages
1,698
In 2001 when I first purchased my 10 Meter Trojan International the bonding system wires had either been removed or were cut.

During my ownership, and during the refit I've replaced most of the bonding system, including each of the four stainless supports for the swim platform and most importantly, the fuel tank(s)

I replaced all of the thru-hulls and seacocks with BRONZE. For the time being, I am excluding the thru hulls and seacocks from the bonding system.

Apparently there has been some controversy regarding these systems and the benefits of eliminating galvanic corrosion & static electricity sparks as compared to the possible danger they may cause by transfering the tremendous electrical energy from a lightning strike.

Now that we've eliminated the fume explosion issue by converting to diesels, I'd like to hear what comments you all have regarding the merits of the bonding system itself and if eliminating the seacocks and thruhulls is a good idea.

Thanks,

RWS
 
As you said, two schools of thought. If you go unbonded, than nothing metal touching the water should be bonded to anything else. Since your boat started out bonded, I would leave it like that and make sure everything metal touching the water is bonded together correctly.
 
I leave out the front "head" stand alone bronze through hulls as an example. On a bonded system. Reducing cable runs on the loop as part of my reason. But would include raw water intakes for the power.
 
Depends on how far apart those through hulls are.
 
I'm not into Bondage but shouldn't this be in NBR?
 
Its a plus to bond everything for a possible lightning strike. More surface area in the water for the strike to disapate the better On the other hand if your not getting any galvanic corrosion on the thru-hulls that are not bonded, consider yourself lucky. If you decide to do it, use 8AWG or better for bonding, 4 AWG or better for main conductor and 6 AWG for secondary conductors for lightning protection as per ABYC.
 
I dont think that a lightning strick can be handled by any wire.
 
Back
Top