Drain plug stuck!

That drilling idea is good! We have to be careful, though, to be sure that nothing we do will break the bedding compound bond between the garboard plug flange and the transom/hull structure.

For slightly damaged threads, you can make a "thread chaser" out of another plug by filing cuts into and across the threads [lengthwise to the plug]. A steel plug could work better than brass. Run the chaser in and out a few times, clean out with a wire brush, then try the real plug. If it's OK, reinstall with Teflon Tape to be sure it won't stick again.
 
Whew, I can't see down there, but I can get the camera close -- it sure is groady, but does show a feature of my Seaswirl (2000 1850) that tickled me. There is no transom core where the garboard drain plug is installed. I guess this keeps both the outside water and the bilge water from getting to the wood in the transom at the plug/collar?

IMG_2497.jpg
 
That may be a common design. Where the hole is only appears to be 1" thick on my transom.

MJK
 
That is common when the design is well thought out. In fact, my limber holes are done that way as well.
 
Back
Top