Lewmar windlass problems

yolo

Member
Joined
Dec 18, 2007
RO Number
29127
Messages
5
folks

when we used the windlass the first time this year it activated the breaker and stopped working. So when I got into dock I took the rope off the unit and ran it without any rope to draw. When I used the switch that causes it to pull rope into the boat it ran fairly freely and did not activate the breaker. But when I used the switch that normally would cause it to feed rope out into the lake it ran slower and activated the breaker. I did this a second time, and in the "pull rope in" position was fine, in the "let rope out" activation it slowed down, and then I used the " pull rope in position" again and it was a bit slower, then when I went to the "let rope out position" it ran slower and activated the breaker again. (don't you love my terminology !! lol)

it is a Lewmar Concept 1 with a 002 gypsy.

any ideas gang ??
__________________
Thank you
Larry

1997 3255 Avanti
7.4L Bravo 3's
Lake Erie, Ontario, Canada
 
Go to rigginghydraulics dot com and find their phone number. They are a Lewmar distributor. Ask to speak to Tom in sales. He seems quite knowledgeable on Lewmar winches.

G
 
two things come to mind when you say you have tripped the breaker. either the load on the windlass was too much, which i doubt as your line did not appear to be jambed. the second is current overload. on the second point two causes come to mind, a short of some kind in the windlass or relay, or very low voltage and as a result the amperage exceeded the breaker capacity. check the health of the battery that the unit runs from with a load tester. my guess would be that you have an internal problem with the relay or windlass motor itself.
 
thank you both... had the motor removed and tested , ok... so looking at a draw in the gear housing for some reason ???
 
I suspect the relay may be shorted; try bypassing it and hooking up the windlass so it runs in the problem pay-out direction. If the problem goes away then it's the relay.
 
Back
Top