packing

32carv

Well-known member
Member
Joined
Nov 4, 2006
RO Number
24150
Messages
1,309
I had my mechanic change the packing in my couplings this spring. Took the boat out today and when I got up on plane we smelled something burning. When I looked in the engine compartment, I noticed that the couplings were leaking pretty bad. Is it possible that they were adjusted too tight and burned up from the friction or could it be something else?
 
Changed the packing in the stuffing box. Unlikely unless he had no idea what he was doing. Usually need to readjust packing after runnig the boat the first time after a packing change. Did he re-adjust the packing glands when you got back to stop the leak? What kind of packing did he put in there? Anything else that could have caused the smell?
 
Very possible the adjusting nut was too tight. Any time conventional packing is replaced or even just the nut is tightened careful attention should be given to monitoring the (hand-felt) temp of the packing gland right away on the first trips out, and conservative speeds may help the packing wear in. If it is not GFO or similar "dripless packing" you should be watching for that drip to insure proper shaft and seal lube & cooling. A lot of friction heat can weaken the shaft. Sometimes replacing the same # of nerw packing rings makes the fit just too tight when getting the adjustment nut back on - in that case it can be better to install one less ring initially and take a run or 2 then install the last ring and adjust the nut the next trip or 2 for whatever you feel is perfect drip timing. That is much better than too tight, burning the dry packing and possibly harming the shaft and starting all over.

Just make sure that smell was from the stuffing box, not transmission or oil spilled on the engine valve covers or similiar, exhaust hose burning from lack of RW cooling injection, or worse, electrical in nature
 
If you did burn your packing, replace it. I'd use GFO packing so you can run dripless.
 
sounds like he adjusted on land not on water

use the gore stuff, it is awesome!
 
You may want to take a close look at things. If they are too tight they can actually gaul the shaft and carve ridges.
 
So, what is the 'rule of thumb' on drip timing? When I put my boat in last week after a LONG winter nap, one side was squirting more than dripping. But after a few days that subsided.

When I ran the boat for the first time the other day, both shafts were dripping. But what I'm not sure of is the minimum number of drips/min. that is considered acceptable.

Jack
 
3 to 4 drips a minute at idle speed in gear. There should be no drips while the shaft isn't turning.
 
I just installed GFO packing. Angle Cut them with a razor blade using the external side of the shafts as my wrapping guide. Used an allen wrench to tap into place. 3 layers, staggered joints. Tightened the packing nut firmly with a wrench (to seat the packing inside the nut), then completely backed off and hand tightened until first snug contact, + 1/4 turn. Then locked in the backing nut.
Mu first time - Does this seem like an appropriate install method?
Real proof will be when she splashes!
Don
 
Back
Top