Anchors

This might be a stupid question to some of you, but it is not to me. We anchor out on the delta which has a incoming and outgoing tide. We have a plow anchor with a very good S/S swivel attached to anchor and chain. When the boat turns with the tide naturally the swivel turns with it. But, the anchor does not turn which now in my opinion would be facing the wrong way. What holds my boat anchored if the anchor is backwards. My husband just kinda looks at me when I ask these questions.
 
Cat's meow--how do you know that the anchor does not turn as the boat swings? If you turn a swivel 180 degrees, there is a very good chance that it will be damaged (--you describe a SS swivel--and most of these are of only one type--which does not take well to right angle bends--they are made only to allow the chain to twist or untwist, not to take bends.

The anchor should stay in the mud (Delta is mud)--and you may not see the plow flukes of the anchor--but it will change direction. If it is not, then there is no strain on the anchor rode. Incidently a plow is not the best anchor for mud--the Fortress or Super Max is--but the advantage of the plow is that it will pivot and reset--a Danforth or Fortress will more likely pull out and not reset as the boat changes direction due to wind, current or tide shifts.
 
quote:

Originally posted by Cats Meow

This might be a stupid question to some of you, but it is not to me. We anchor out on the delta which has a incoming and outgoing tide. We have a plow anchor with a very good S/S swivel attached to anchor and chain. When the boat turns with the tide naturally the swivel turns with it. But, the anchor does not turn which now in my opinion would be facing the wrong way. What holds my boat anchored if the anchor is backwards. My husband just kinda looks at me when I ask these questions.





I have an uncle who anchors a 37' sailboat in the Delta with a CQR plow anchor and does fine. He has an all-chain rode.

All a swivel does is keep the rode from twisting if it makes a couple of trips around the anchor. I use a big ACCO swivel that rotates freely and acts like a shackle (it essentially has a shackle on both ends).

If you pull a fluke anchor like a Danforth or Fortress hard from a direction that is 180 degrees away from the direction in which it is set, you run a chance that the anchor will break loose. Sometimes the anchor may turn or reset, sometimes not.

A plow anchor is more lkely to turn around in the mud and stay anchored, but like thataway4 wrote, the plow will not have the holding power in the mud that a good fluke anchor will.

In the Delta, I've found that boats wander around the anchor at slack current when there is little or no wind. If a boat pulls on the anchor from the wrong direction, that pull is very light and will not drag the anchor loose. There is a chance that the rode can foul on the anchor, though. If you have any breeze at all the wind and returning current will usually reposition the boat within 180 degrees of the original anchor setting position and there will be no problems when the stronger pull resumes.

There may be problems if you use a single main anchor in a location where the prevailing wind blows in the same direction or a direction closely opposite to the current. In a situation like that you could get caught in a current shift with the boat pulling hard against the backside of the anchor, breaking the anchor loose.
 
I also cruise that northwest area and agree with OS. I find a 3 to 1 scope calculated to high tide is all i need to sleep in peace, and keep from bumoing into the next boat in the cove. But and this is critical as far as i am concerned my rode is all chain. I would never do that scope with a chain rope combo need more scope to ofset weight loss.
 
Dang, I really started it!

Heh.

Old_Salt, point taken. I guess I didn't word things specific enough. My signature says I'm in Maryland, which I stupidly though would imply Chesapeake Bay (and that everybody knows what conditions we have here...duh!). My goal was to get Florida input as I know the tidal changes are similar (we're a couple of feet) along with bottom conditions (we've got sand and mud, some stumps, too, in the creeks, but they help...at least until you try to leave!). I also meant to really impress that I wanted input on anchors for the Bahamas. Obviously, I did a poor job. However, you really did open my mind to different conditions in different areas. So, THANKS!

Just so you know, when I said “I too have seen the 3:1 scope idiots. " I'm talking about:

- 6-8 feet of water
- 2 foot tidal change
- "captain" lets the anchor drop 'til it hits bottom. Stops the windlass, and has a beer. They don't set it. They don't worry about it. And of course, they drift!

So we need to replace my poorly worded “I too have seen the 3:1 scope idiots. " with something that fits for all locations.

Dang, I love this forum!
 
OS, you're my hero. I'm from just down the coast a bit, Gibsons/Gower Pt., and was thinking "5:1, 7:1 scopes:, my god how much rode do these guys carry. Around here it's rarely less than 100' of water and add an average 13' tide swing. For the last 40 years anyway in this area, myself, my family and our neighbours anchoring boats from 12 to 90', usually with Danforth style, varying sizes appropriate to the boat, 1 to 1 1/5 times boat length of chain and rode, more recently nylon to a 3:1 scope at low water has held, when properly set.

James
 
tcijoe:

It is only 7:15 am on the West Coast, and you have already made my day! Thank You!

Old_Salt

Y'r Obedient Servant in Halfmoon Bay, B.C., Canader, EH!
 
Thanks all. We never have had a problem with our anchor, it was just one of those questions that I asked my husband. I received one of the eye rolling looks so I told him I would find out by myself. By the way, about 3 months ago we went to all chain. So I really shouldn't be worried about to much. We always come back to dock when the wind is really to bad to anchor out at night.
 
mixman:

You said,"Just so you know, when I said “I too have seen the 3:1 scope idiots. " I'm talking about:

- 6-8 feet of water We'll go 20-30 feet at the shallow end
- 2 foot tidal change Uh!uh! say 10-15 feet.
- "captain" lets the anchor drop 'til it hits bottom. Stops the windlass, No powered windlass. Just crack the gypsy and let 'er rip for about 10-15 feet more than the depth. Stay cool. Check out the shoreline, rocks, trees, peaks for location, then as you drift away from the anchor and the rode tightens, let out another 10-15 feet
and has a beer. MacEwans Scotch Ale
They don't set it. Let out another 15-20 feet. It's has been setting all by itself and a little help from Ma Nature!
They don't worry about it. We're talking about the increasingly lower levels of the beer in the glass here, right? Of course I worry!
And of course, they drift! Towards the beer storage locker. It's safe to do that, now that we are locked to the bottom.
Then we signal the Admiral to bunt it in reverse a couple of times, let out all the scope thats going, but never more than 3:1 (which would be against the Code Of The PacificNorthWest) and back down until the trees stop moving. When she puts it back in neutral on your signal and the boat leaps forward, it's all good!
So we need to replace my poorly worded “I too have seen the 3:1 scope idiots. " with something that fits for all locations. Done.

Dang, I love this forum!" Me, too, Kurt. Thanks for the neighbourly sharing of regional anchoring techniques.

Old_Salt
 
This definitely is Boatered!
I'm upgrading my anchor, going to the largest size I can without having to change the rollers.
 
I anchor in mud and sand. We have a Delta plow which works always fine. I also have danforth fluke backup anchor which I also use as aft. Once set in mud it will take considerable force to get it back up. In sand and mud the fluke anchor is awesome, some debris, gravel, grass etc in the way and it will not set right.
 
Here's another perspective:
My boat is 18'. I'll often drop the hook 6 times or more in a single day, for meals, boat or bird watching and naps. When we anchor for the night, we're more often than not in <5' MLW. I'll always put out the 8# (genuine) Danforth first...if it skates or drags I'll deploy the claw. I anchor off the stern and us NO chain; it's easier and cleaner that way.

What I'm getting at is that what you drop and your technique can depend on the size of your boat and level of experience and comfort level.
http://baylinerownersclub.org/forum/showthread.php?t=9780
 
Back
Top